Nissan Teana J32. Manual — part 1225
VTL-86
< ON-VEHICLE REPAIR >
[WITH 7 INCH DISPLAY]
INTAKE SENSOR
Removal and Installation
INFOID:0000000003894498
REMOVAL
1.
Remove evaporator pipe assembly. Refer to
.
2.
Disconnect intake sensor connector.
3.
Slide evaporator (1) toward the right side of the vehicle (as
shown in the figure), and then remove intake sensor (2).
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply compressor oil to them when installing.
• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor
can be located in the same position.
• Do not rotate the bracket insertion part when removing and installing the intake sensor.
• Check for refrigerant leakage when charging refrigerant.
37. Defroster door link
38.
Foot door link
39.
Max. cool door lever
40. Foot door lever
41.
Defroster door lever
42.
Adapter case
43. Distributor lower case
44.
Ventilator door
45.
Intake sensor
46. Intake sensor bracket
47.
Foot door
48.
Max. cool door
49. Defroster door
50.
Air mix door (Slide door)
for symbols in the figure.
JPIIA0907ZZ
BLOWER UNIT
VTL-87
< ON-VEHICLE REPAIR >
[WITH 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
BLOWER UNIT
Exploded View
INFOID:0000000003894499
DISASSEMBLY
1.
Blower unit
2.
Heater & cooling unit assembly
3.
Steering member
4.
Instrument stay
5.
Instrument panel assembly
Refer to
for symbols in the figure.
JPIIA0914GB
VTL-88
< ON-VEHICLE REPAIR >
[WITH 7 INCH DISPLAY]
BLOWER UNIT
Removal and Installation
INFOID:0000000003940511
REMOVAL
1.
Remove instrument panel assembly. Refer to
2.
Remove mounting nuts (A), and then remove instrument stay
(1).
3.
Disconnect intake door motor and blower motor connectors.
1.
Shutter box case
2.
Intake door
3.
Intake door motor
4.
Blower motor
5.
Intake lower case
6.
Outlet seal
7.
Intake upper case
8.
Intake seal
JPIIA0908ZZ
JPIIA0909ZZ
BLOWER UNIT
VTL-89
< ON-VEHICLE REPAIR >
[WITH 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
4.
Remove heater & cooling unit assembly mounting bolts (A) and blower unit mounting bolts (B).
5.
Remove steering member mounting bolts (C) (right).
6.
Remove blower unit (2) while pulling steering member (1).
INSTALLATION
Installation is basically the reverse order of removal.
JPIIA0910ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст