Nissan Tiida C11. Manual — part 1101
MWI-94
< ON-VEHICLE REPAIR >
COMBINATION METER
ON-VEHICLE REPAIR
COMBINATION METER
Removal and Installation
INFOID:0000000001569484
COMBINATION METER
Removal
NOTE:
LH drive shown RH drive similar.
1.
Pull instrument finisher E backward by approximately 30
degrees while disengaging the metal clips and pawl.
2.
Remove front pillar garnish. Refer to
INT-20, "Removal and Installation"
.
3.
Pull up instrument side panel and disengage pawls.
4.
Remove instrument side panel.
5.
Insert a remover into upper space of instrument mask.
6.
Disengage pawls, and then remove instrument side mask.
7.
Insert a remover into space of instrument side finisher.
8.
Disengage metal clips, and then remove instrument side fin-
isher.
WIIA1224E
PIIB2439J
PIIB2448E
PIIB2440E
MWI
COMBINATION METER
MWI-95
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
9.
Insert suitable tool into the bottom gap of side ventilator assem-
bly after removing the instrument side mask, push against A and
B as shown to disengage the pawls.
10. Lift the side ventilator up from the bottom, pull backward while
disengaging the side ventilator assembly's upper pawls, and
then remove the side ventilator.
11. Remove screws, and disengage pawls.
12. Remove steering column cover upper.
13. Remove screws from instrument upper panel right side.
14. Lift the instrument upper panel up, disengage metal clips.
15. Pull backward and disengage clips.
16. Remove cluster lid A.
WIIA1226E
PIIB3976E
PIIB3969E
PIIB2880E
MWI-96
< ON-VEHICLE REPAIR >
COMBINATION METER
17. Remove screws (A) and metal clip (B), and remove combination
meter.
Installation
Installation is in the reverse order of removal.
PKIC0703E
MWI
COMBINATION METER
MWI-97
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
DISASSEMBLY AND ASSEMBLY
COMBINATION METER
Disassembly and Assembly
INFOID:0000000001716785
COMBINATION METER
Disassembly
1.
Remove the combination meter. Refer to
MWI-94, "Removal and Installation"
2.
Disengage the eight tabs to separate front cover (1) from the
unified meter control unit assembly (2).
Assembly
Assembly is in the reverse order of disassembly.
LIIA2582E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст