Nissan Tiida C11. Manual — part 1443
WCS-54
< ECU DIAGNOSIS >
COMBINATION METER
Fail Safe
INFOID:0000000001728310
The combination meter performs a fail-safe operation for the functions listed below when communication is
lost.
ALNIA0862GB
WCS
COMBINATION METER
WCS-55
< ECU DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
DTC Index
INFOID:0000000001728311
NOTE:
“TIME” indicates the following.
• 0: Indicates that a malfunction is detected at present.
• 1-63: Indicates that a malfunction was detected in the past. (Displays number of ignition switch OFF
→
ON
cycles after malfunction is detected. Self-diagnosis result is erased when “63” is exceeded.)
Function
Specifications
Speedometer
Zero indication.
Tachometer
Fuel gauge
Illumination control
Meter illumination
Change to nighttime mode when communication is lost.
Segment LCD
Odometer
Freeze current indication.
Buzzer
Buzzer turns off.
Warning lamp/indicator lamp
ABS warning lamp
Lamp turns on when communication is lost.
Brake warning lamp
ESP OFF indicator lamp
SLIP indicator lamp
Side and headlight indicator
Lamp turns off when communication is lost.
Low water temperature indicator lamp
High water temperature warning lamp
Malfunction indicator
Power steering warning lamp
Air bag warning lamp
High beam indicator
Turn signal indicator lamp
Intelligent Key system warning lamp
CRUISE indicator lamp
Oil pressure warning lamp
Door warning lamp
Front fog lamp indicator
Rear fog lamp indicator
O/D OFF indicator lamp
Lamp turns off when disconnected.
Charge warning lamp
Driver and passenger seat belt warn-
ing lamp
CONSULT-III display
Malfunction
Reference
page
CAN COMM CIRC
[U1000]
Malfunction is detected in CAN communication.
CAUTION:
Even when there is no malfunction on CAN communication system, malfunction may be
misinterpreted when battery has low voltage (when maintaining 7 - 8 V for about 2 sec-
onds) or 10A fuse [No. 19, located in the fuse block (J/B)] is disconnected.
VEHICLE SPEED
CIRC
[B2205]
Malfunction is detected when an erroneous speed signal is input.
CAUTION:
Even when there is no malfunction on speed signal system, malfunction may be misin-
terpreted when battery has low voltage (when maintaining 7 - 8 V for about 2 seconds).
WCS-56
< ECU DIAGNOSIS >
BCM (BODY CONTROL MODULE)
BCM (BODY CONTROL MODULE)
Reference Value
INFOID:0000000001728312
VALUES ON THE DIAGNOSIS TOOL
Monitor Item
Condition
Value/Status
AIR COND SW
A/C switch OFF
OFF
A/C switch ON
ON
AUT LIGHT SYS
Outside of the room is dark
OFF
Outside of the room is bright
ON
AUTO LIGHT SW
Lighting switch OFF
OFF
Lighting switch AUTO
ON
BACK DOOR SW
Back door closed
OFF
Back door opened
ON
BATTERY VOLT
NOTE:
Diesel engine models
only
Ignition switch ON
Approximately the same as power
supply voltage
CDL LOCK SW
Door lock/unlock switch does not operate
OFF
Press door lock/unlock switch to the LOCK side
ON
CDL UNLOCK SW
Door lock/unlock switch does not operate
OFF
Press door lock/unlock switch to the UNLOCK side
ON
DOOR SW-AS
Passenger door closed
OFF
Passenger door opened
ON
DOOR SW-DR
Driver door closed
OFF
Driver door opened
ON
DOOR SW-RL
Rear LH door closed
OFF
Rear LH door opened
ON
DOOR SW-RR
Rear RH door closed
OFF
Rear RH door opened
ON
ELEC PWR CUT
NOTE:
Diesel engine models
only
Engine running
Fan switch ON (when engine coolant is
cool)
NOTE:
Depending on the ambient tempera-
ture, battery voltage, etc.
OFF
The current status maintained with the
signal from ECM received.
FREEZ
• Fan switch OFF
• Fan switch ON after engine warming
UP
NOTE:
Depending on the engine coolant
temperature, ambient temperature,
battery voltage, etc.
INHBT
ENG COOLNT T
NOTE:
Diesel engine models
only
Engine running
Approximately the same as engine
water temperature
ENGINE RPM
NOTE:
Diesel engine models
only
Engine running
Approximately the same as tachom-
eter reading
WCS
BCM (BODY CONTROL MODULE)
WCS-57
< ECU DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ENGINE RUN
Engine stopped
OFF
Engine running
ON
ENGINE STATUS
NOTE:
Diesel engine models
only
Engine stopped
STOP
While the engine stalls
STALL
Engine running
RUN
At engine cranking
CRA
FAN ON SIG
Fan switch OFF
OFF
Fan switch ON
ON
FR FOG SW
Front fog lamp switch OFF
OFF
Front fog lamp switch ON
ON
FR WASHER SW
Front washer switch OFF
OFF
Front washer switch ON
ON
FR WIPER LOW
Front wiper switch OFF
OFF
Front wiper switch LO
ON
FR WIPER HI
Front wiper switch OFF
OFF
Front wiper switch HI
ON
FR WIPER INT
Front wiper switch OFF
OFF
Front wiper switch INT
ON
FR WIPER STOP
Any position other than front wiper stop position
OFF
Front wiper stop position
ON
HAZARD SW
When hazard switch is not pressed
OFF
When hazard switch is pressed
ON
LIGHT SW 1ST
Lighting switch OFF
OFF
Lighting switch 1st
ON
H/L SW POS
Headlamp switch OFF
OFF
Headlamp switch 1st
ON
HI BEAM SW
High beam switch OFF
OFF
High beam switch HI
ON
HOOD SW
Close the hood
NOTE:
Vehicles without theft warning system are OFF-fixed
OFF
Open the hood
ON
H/L WASH SW
NOTE:
The item is indicated, but not monitored
OFF
IGN ON SW
Ignition switch OFF or ACC
OFF
Ignition switch ON
ON
IGN SW CAN
Ignition switch OFF or ACC
OFF
Ignition switch ON
ON
INT VOLUME
Wiper intermittent dial is in a dial position 1 - 7
1 - 7
I-KEY LOCK
1
LOCK button of Intelligent Key is not pressed
OFF
LOCK button of Intelligent Key is pressed
ON
I-KEY UNLOCK
1
UNLOCK button of Intelligent Key is not pressed
OFF
UNLOCK button of Intelligent Key is pressed
ON
KEY SW
2
Mechanical key is removed from key cylinder
OFF
Mechanical key is inserted to key cylinder
ON
Monitor Item
Condition
Value/Status
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст