Nissan Tiida C11. Manual — part 38
BCS-16
< FUNCTION DIAGNOSIS >
DIAGNOSIS SYSTEM (BCM)
DIAGNOSIS SYSTEM (BCM)
COMMON ITEM
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
INFOID:0000000001451463
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
1: With remote keyless entry system
2: With Intelligent Key
BCM
Diagnosis mode
Function Description
WORK SUPPORT
Changes the setting for each system function.
SELF-DIAG RESULTS
Displays the diagnosis results judged by BCM. Refer to
CAN DIAG SUPPORT MNTR
Monitors the reception status of CAN communication viewed from BCM.
DATA MONITOR
The BCM input/output signals are displayed.
ACTIVE TEST
The signals used to activate each device are forcibly supplied from BCM.
ECU IDENTIFICATION
The BCM part number is displayed.
CONFIGURATION
• Enables to read and save the vehicle specification.
• Enables to write the vehicle specification when replacing BCM.
System
Sub system selection item
Diagnosis mode
WORK SUPPORT
DATA MONITOR
ACTIVE TEST
BCM
BCM
×
Door lock
DOOR LOCK
×
×
×
Rear window defogger
REAR DEFOGGER
×
×
Warning chime
BUZZER
×
×
Interior room lamp timer
INT LAMP
×
×
×
Remote keyless entry system
1
MULTI REMOTE ENT
×
×
×
Exterior lamp
HEAD LAMP
×
×
×
Wiper and washer
WIPER
×
×
×
Turn signal and hazard warning lamps
FLASHER
×
×
Air conditioner
AIR CONDITONER
×
Intelligent Key system
2
INTELLIGENT KEY
×
Combination switch
COMB SW
×
Immobilizer
IMMU
×
×
Interior room lamp battery saver
BATTERY SAVER
×
×
×
Trunk open (sedan)/Back door open
(hatch back)
DOOR LOCK
×
×
Vehicle security system
THEFT ALM
×
×
×
Signal buffer system
SIGNAL BUFFER
×
×
PTC heater system
PTC HEATER
×
×
BCS
DIAGNOSIS SYSTEM (BCM)
BCS-17
< FUNCTION DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
BCM : CONSULT-III Function (BCM - BCM)
INFOID:0000000001451464
WORK SUPPORT
DOOR LOCK
DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK)
INFOID:0000000001451465
WORK SUPPORT
DATA MONITOR
1: With Intelligent Key
2: With remote keyless entry system
ACTIVE TEST
Item
Description
RESET SETTING VALUE
Return a value set with WORK SUPPORT of each system to a default value in factory shipment.
Work Item
Description
SECURITY DOOR LOCK SET
Anti hijack function mode can be changed in this mode.
• ON: Anti hijack mode is active.
• OFF: Anti hijack mode is inactive.
AUTO LOCK SET
Auto door lock time can be changed in this mode.
• MODE 1: 1 minute
• MODE 2: 2 minutes
• MODE 3: 3 minutes
• MODE 4: 4 minutes
• MODE 5: 5 minutes
Monitor Item
[Unit}
Description
IGN ON SW [ON/OFF]
Indicates condition of ignition switch in ON position.
PUSH SW
1
[ON/OFF]
Indicates condition of ignition knob switch.
KEY SW
2
[ON/OFF]
Indicates condition of key switch.
CDL LOCK SW [ON/OFF]
Indicates condition of door lock and unlock switch.
CDL UNLOCK SW [ON/OFF]
Indicates condition of door lock and unlock switch.
DOOR SW-DR [ON/OFF]
Indicates condition of front door switch (driver side).
DOOR SW-AS [ON/OFF]
Indicates condition of front door switch (passenger side).
DOOR SW-RR [ON/OFF]
Indicates condition of rear door switch RH.
DOOR SW-RL [ON/OFF]
Indicates condition of rear door switch LH.
TRNK OPNR SW [ON/OFF]
Indicates condition of back door switch.
BACK DOOR SW [ON/OFF]
Indicates condition of back door switch.
KEYLESS LOCK
2
[ON/OFF]
Indicates condition of lock signal from key fob.
KEYLESS UNLOCK
2
[ON/OFF]
Indicates condition of unlock signal from key fob.
I-KEY LOCK
1
[ON/OFF]
Indicates condition of lock signal from Intelligent Key.
I-KEY UNLOCK
1
[ON/OFF]
Indicates condition of unlock signal from Intelligent Key.
Test item
Description
DOOR LOCK
This test is able to check door lock operation [ALL LOCK/ALL UNLOCK/DR UNLOCK/
OTHER UNLOCK].
SUPER LOCK
*
This test is able to check super lock operation [LOCK (SET)/UNLOCK (RELEASE)].
BCS-18
< FUNCTION DIAGNOSIS >
DIAGNOSIS SYSTEM (BCM)
*
: With super lock
REAR WINDOW DEFOGGER
REAR WINDOW DEFOGGER : CONSULT-III Function (BCM - REAR DEFOGGER)
INFOID:0000000001451466
DATA MONITOR
ACTIVE TEST
BUZZER
BUZZER : CONSULT-III Function (BCM - BUZZER)
INFOID:0000000001451467
DATA MONITOR
ACTIVE TEST
DOOR LOCK IND
This test is able to check door lock indicator (built in door lock and unlock switch on center
console) operation [ON/OFF].
TRUNK/BACK DOOR
This test is able to check trunk/back door lock operation [LOCK (SET)/UNLOCK (RE-
LEASE)].
Test item
Description
Monitor Item
[Unit]
Description
ENGINE STATUS [RUN/
STOP]
Indicates engine running status.
IGN ON SW [ON/OFF]
Indicates condition of ignition switch in ON position.
REAR DEF SW [ON/OFF]
Displays “Press (ON)/other (OFF)” status determined with the rear window defogger switch.
Test Item
Description
REAR DEFOGGER
Give a drive signal to the rear window defogger relay to activate it.
Monitor Item
[Unit]
Description
IGN ON SW [ON/OFF]
Ignition switch (ON) status judged by ignition power supply input.
PUSH SW
1
[ON/OFF]
Ignition knob status.
KEY SW
2
[ON/OFF]
Key switch status.
DOOR SW -DR [ON/OFF]
Front door switch (driver side) status judged by BCM.
DOOR SW -AS [ON/OFF]
Front door switch (passenger side) status judged by BCM.
DOOR SW -RR [ON/OFF]
Rear door switch RH status judged by BCM.
DOOR SW -RL [ON/OFF]
Rear door switch LH status judged by BCM.
BACK DOOR SW [ON/OFF]
Back door switch status judged by BCM.
CDL LOCK SW [ON/OFF]
Door lock/unlock switch status.
CDL UNLOCK SW [ON/OFF]
Door lock/unlock switch status.
LIGHTING SW [ON/OFF]
Lighting switch status judged by the lighting switch signal read with combination switch reading func-
tion.
TRNK OPNR SW [ON/OFF]
Trunk switch status.
Test Item
Description
LIGHT WARN ALM
The light reminder warning operation can be checked by operating the relevant function (On/Off).
KEY REMINDER WARN
The key reminder warning operation can be checked by operating the relevant function (On/Off).
BCS
DIAGNOSIS SYSTEM (BCM)
BCS-19
< FUNCTION DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
INT LAMP
INT LAMP : CONSULT-III Function (BCM - INT LAMP)
INFOID:0000000001451468
DATA MONITOR
1: With Intelligent Key
2: With remote keyless entry
ACTIVE TEST
MULTIREMOTE ENT
MULTIREMOTE ENT : CONSULT-III Function (BCM - MULTIREMOTE ENT)
INFOID:0000000001451469
WORK SUPPORT
BACK DR OPEN WARN
The back door open warning operation can be checked by operating the relevant function (On/Off).
DOOR WARNING IND
The door open warning operation can be checked by operating the relevant function (On/Off).
Test Item
Description
Monitor item
[Unit]
Description
IGN ON SW [ON/OFF]
Ignition switch (ON) status judges from IGN signal (ignition power supply)
PUSH SW
1
[ON/OFF]
Push switch status received from Intelligent Key unit by CAN communication
KEY SW
2
[ON/OFF]
The switch status input from key switch
DOOR SW-DR [ON/OFF]
The switch status input from front door switch (driver side)
DOOR SW-AS [ON/OFF]
The switch status input from front door switch (passenger side)
DOOR SW-RR [ON/OFF]
The switch status input from rear door switch RH
DOOR SW- RL [ON/OFF]
The switch status input from rear door switch LH
BACK DOOR SW [ON/OFF]
The switch status input from back door switch
CDL LOCK SW [ON/OFF]
Lock switch status input from door lock and unlock switch
CDL UNLOCK SW [ON/OFF]
Unlock switch status input from door lock and unlock switch
KEYLESS LOCK
2
[ON/OFF]
Lock signal status received from remote keyless entry receiver (integrated in the
BCM)
KEYLESS UNLOCK
2
[ON/OFF]
Unlock signal status received from remote keyless entry receiver (integrated in the
BCM)
I-KEY LOCK
1
[ON/OFF]
Lock signal status received from Intelligent Key unit by CAN communication
I-KEY UNLOCK
1
[ON/OFF]
Unlock signal status received from Intelligent Key unit by CAN communication
I-KEY ALL UNL
1
[ON/OFF]
Unlock signal status received from Intelligent Key unit by CAN communication
Test item
Operation
Description
INT LAMP
ON
Outputs the interior room lamp control signal to turn the interior room lamps ON.
[Map lamp, personal lamp, room lamp, luggage room lamp (when applicable lamps
switch is in DOOR position.)]
OFF
Stops the interior room lamp control signal to turn the interior room lamps.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст