Nissan Tiida C11. Manual — part 1294
DISASSEMBLY
TM-227
< DISASSEMBLY AND ASSEMBLY >
[TYPE 1 (4AT: RE4F03B)]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
d.
Remove O-ring (1) from differential lubricant hole.
23. Remove plug from converter housing.
24. Remove O-ring from plug.
25. Remove final drive assembly (1) from transaxle case.
26. Remove differential side bearing adjusting shim from transaxle
case.
27. Remove RH differential side oil seal from converter housing
using suitable tool.
CAUTION:
Do not scratch converter housing.
SCIA5918J
SCIA6034J
SCIA4938E
SCIA3283E
TM-228
< DISASSEMBLY AND ASSEMBLY >
[TYPE 1 (4AT: RE4F03B)]
DISASSEMBLY
28. Remove differential lubricant tube and clips from converter
housing.
29. Remove oil pump assembly according to the following procedures.
a.
Remove O-ring from input shaft assembly (high clutch drum).
b.
Remove oil pump assembly fitting bolts, and then remove oil
pump assembly (1) from transaxle case.
c.
Remove O-ring from oil pump assembly (1).
d.
Remove bearing race (1) and thrust washer (2) from oil pump
assembly (3).
SCIA3284E
SCIA5634E
SCIA6036J
SCIA6957E
DISASSEMBLY
TM-229
< DISASSEMBLY AND ASSEMBLY >
[TYPE 1 (4AT: RE4F03B)]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
30. Remove brake band according to the following procedures.
a.
Loosen lock nut (1), and then remove anchor end pin (2) and
lock nut (1) as a set from transaxle case.
b.
Remove brake band from transaxle case.
• To prevent brake linings from cracking or peeling, do not
stretch the flexible band unnecessarily. When removing
brake band, always secure it with a clip as shown.
Leave the clip in position after removing brake band.
c.
Check brake band facing for damage, cracks, wear or burns.
31. Remove input shaft assembly (high clutch assembly) and
reverse clutch assembly according to the following procedures.
a.
Remove input shaft assembly (high clutch assembly) (1) with
reverse clutch assembly (2).
SCIA6037J
SAT038D
SAT039D
SAT040D
SCIA6038J
TM-230
< DISASSEMBLY AND ASSEMBLY >
[TYPE 1 (4AT: RE4F03B)]
DISASSEMBLY
b.
Remove input shaft assembly (high clutch assembly) (1) from
reverse clutch assembly (2).
c.
Remove needle bearing (1) from input shaft assembly (high
clutch drum) (2).
• Inspect needle bearing (1) and input shaft assembly (high
clutch drum) (2), and replace if damaged or worn.
32. Remove needle bearing from high clutch hub.
• Inspect needle bearing, and replace if damaged or worn.
33. Remove high clutch hub from front sun gear.
• Inspect high clutch hub, and replace if damaged or worn.
34. Remove needle bearing from front sun gear.
• Inspect needle bearing, and replace if damaged or worn.
SCIA6958E
SCIA6959E
SAT371D
SAT370D
SAT369D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст