Nissan Tiida C11. Manual — part 1231
STR-10
< COMPONENT DIAGNOSIS >
[HR16DE]
STARTING SYSTEM
STARTING SYSTEM
Wiring Diagram
INFOID:0000000001712886
AWBWA0019GB
STARTING SYSTEM
STR-11
< SYMPTOM DIAGNOSIS >
[HR16DE]
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
SYMPTOM DIAGNOSIS
STARTING SYSTEM
Symptom Table
INFOID:0000000001712887
Symptom
Reference
No normal cranking
Refer to
XX-XX, "*****"
.
Starter motor does not rotate
STR-12
< PRECAUTION >
[HR16DE]
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000001689454
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SR and SB section of
this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
STARTER MOTOR
STR-13
< ON-VEHICLE REPAIR >
[HR16DE]
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
ON-VEHICLE REPAIR
STARTER MOTOR
Removal and Installation
INFOID:0000000001689433
REMOVAL
1.
Disconnect the battery cable from the negative terminal.
2.
Remove “B” terminal nut and “B” terminal harness.
3.
Remove “S” terminal nut and “S” terminal harness.
4.
Remove starter motor bolts.
5.
Remove starter motor upward from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Be sure to tighten “B” terminal nut carefully.
1.
Cylinder block
2.
“B” terminal harness
3.
“S” terminal harness
4.
Starter motor
Vehicle front
PKIC0987E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст