Nissan Tiida C11. Manual — part 79
BRC-82
< PREPARATION >
[ABS]
PREPARATION
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000001691372
Tool number
Tool name
Description
GG94310000
Flare nut torque wrench
a: 10 mm (0.39 in)
Removing and installing each brake
piping
NT406
WHEEL SENSORS
BRC-83
< REMOVAL AND INSTALLATION >
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
REMOVAL AND INSTALLATION
WHEEL SENSORS
Removal and Installation
INFOID:0000000001691408
REMOVAL
Be careful of the following.
CAUTION:
• When removing the sensor, do not rotate it if possible, and not forcibly pull the sensor harness.
• Before removing front or rear wheel hub, remove wheel sensor to avoid sensor wiring damage.
INSTALLATION
Be certain to tighten bolts to the specified torque. Be careful of the following:
• Check the inside of the sensor mounting hole for foreign material, the rotor surface for iron chips and other
foreign material, and if anything is non-standard, clean it before installation, or replace it.
• When installing the front sensor, completely push in the strut bracket and body bracket rubber grommets
until they lock so that the sensor harness does not become twisted. In addition, there should be no twists in
the harness when installed. Install the harness so that the painted part faces the outside of the vehicle.
• When installing the rear sensor, completely push in the rubber bracket of the suspension arm bracket and
lock the marking area of the side member harness mount so that the sensor harness will not be twisted. In
addition, there should be no twists in the harness when installed.
MFIB9029E
BRC-84
< REMOVAL AND INSTALLATION >
[ABS]
SENSOR ROTOR
SENSOR ROTOR
Removal and Installation
INFOID:0000000001691409
FRONT
• Because the sensor rotor is integrated with the wheel bearing, replace it together with the wheel bearing
assembly. Refer to
FAX-7, "Removal and Installation"
.
REAR
• During removal and installation, remove the wheel hub (brake drum). Refer to
.
CAUTION:
The sensor rotor is a non-reusable part, it must be replaced by an new part when removing it.
ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
BRC-85
< REMOVAL AND INSTALLATION >
[ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
Removal and Installation
INFOID:0000000001691410
REMOVAL
Be careful of the following.
CAUTION:
• Before servicing, disconnect the battery cables.
• To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being dam-
aged. To install, use a flare nut torque wrench and tighten to the specified torque.
• Do not apply excessive impact to the actuator, such as dropping it.
INSTALLATION
Be careful of the following.
• When setting the actuator in the bracket, push it in until it locks.
• Tighten the mounting bolts and nuts to the specified torque.
• After the work, breed the air from the brake piping. Refer to
.
• After installing the vehicle harness connector in the actuator, make sure the connector is securely locked.
SFIA1183E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст