Nissan Tiida C11. Manual — part 1153
FRONT SEAT
SE-13
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
REMOVAL AND INSTALLATION
FRONT SEAT
Exploded View
INFOID:0000000001710927
Driver Seat
1.
Headrest
2.
Headrest holder (free)
3.
Headrest holder (locked)
4.
Seat assembly
5.
Seat belt buckle
6.
Rear leg cover
7.
Push nut
8.
Seat cushion inner finisher
9.
Snap pin
10. Reclining lever
11. Lever cover
12. Lifter lever
13. Seat cushion finisher B
14. Reclining device control wire
15. Front leg cover
16. Seat cushion lower finisher
17. Seat cushion outer finisher
18. Seat cushion pad
19. Seat cushion trim
WIIA1285E
SE-14
< REMOVAL AND INSTALLATION >
FRONT SEAT
Removal and Installation
INFOID:0000000001710898
CAUTION:
• When removing and installing, use shop cloths to protect parts from damage.
• Disconnect both battery cables before work.
MANUAL SEAT
Removal
1.
Seat assembly
2.
Head rest holder (free)
3.
Headrest
4.
Headrest holder (locked)
5.
Seat cushion outer finisher
6.
Front leg cover
7.
Reclining device control wire
8.
Seat cushion inner finisher
9.
Snap pin
10. Reclining lever knob
11. Lever cover
12. Seat belt buckle
13. Push nut
14. Rear leg cover
WBIA0848E
FRONT SEAT
SE-15
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
1.
Remove the rear leg covers.
2.
Remove the front leg covers.
3.
Remove the mounting bolts on the back side of the front seat. (TORX bolt: T50)
4.
Remove the mounting bolts on the front side of the front seat. (TORX bolt: T50)
5.
Disconnect the harness connector under the seat and remove harness securing clips.
CAUTION:
Before removal, be sure to turn ignition switch OFF, disconnect both battery cables, and then wait
for at least 3 minutes.
6.
Set seatback in a neutral position, and then remove front seat from the vehicle.
Installation
Install in the reverse order of removal. Be careful of the following three points.
• Before the installation, confirm that the inside and outside slide rails are locked at the same positions.
• Confirm that the slide rail location pin is set to the hole on the floor.
• Clamp the harness in position.
PIIB2669J
PIIB2668J
SE-16
< REMOVAL AND INSTALLATION >
REAR SEAT
REAR SEAT
Exploded View
INFOID:0000000001710932
60:40 SPLIT FOLD DOWN SLIDING SEAT
WIIA1305E
1.
Headrest
2.
Headrest holder (locked)
3.
Headrest holder (free)
4.
Right seatback frame
5.
Right seatback pad and trim
6.
Seatback side
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст