Nissan Tiida C11. Manual — part 1194
SRC-4
< BASIC INSPECTION >
DIAGNOSIS AND REPAIR WORK FLOW
>> GO TO 3
3.
TECHNICAL SERVICE BULLETINS
Check for technical service bulletins.
>> GO TO 4
4.
USER MODE
Perform self-diagnosis using the "AIR BAG" warning lamp in User mode. Refer to
.
>> GO TO 5
5.
SELF-DIAGNOSIS
Perform SELF-DIAGNOSIS. Refer to
SRC-5, "Trouble Diagnosis with CONSULT-III"
(w/CONSULT-III) or
SRC-13, "Self-Diagnosis Function (Without CONSULT-III)"
(w/o CONSULT- III).
>> GO TO 6
6.
REPLACE PART
Replace the malfunctioning part.
>> GO TO 7
7.
FINAL CHECK
Check SRS using Diagnosis mode and User mode.
Does Diagnosis mode and User mode indicate SRS normal?
YES
>> Inspection end.
NO
>> GO TO 5
INTERMITTENT INCIDENT
SRC-5
< BASIC INSPECTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
INTERMITTENT INCIDENT
Inspection Procedure
INFOID:0000000001396345
INTERMITTENT TROUBLE
An intermittent incident may have occured in the past but is not being detected currently. This DTC will not be
detected on SELF DIAG [CURRENT], but may be viewed on SELF DIAG [PAST] using CONSULT-III.
Trouble Diagnosis with CONSULT-III
INFOID:0000000001396346
DIAGNOSTIC PROCEDURE 4
Check SRS Repair History
1.
CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR
Check repair history of the SRS.
Have any previous repairs been made to the SRS?
Yes
>> Self-diagnostic result “SELF-DIAG [PAST]” (previously stored in the memory) might not be erased
after repair. Proceed to "DIAGNOSTIC PROCEDURE 3". Refer to
No
>> Proceed to "DIAGNOSTIC PROCEDURE 2". Refer to
.
SRC-6
< FUNCTION DIAGNOSIS >
SRS AIR BAG SYSTEM
FUNCTION DIAGNOSIS
SRS AIR BAG SYSTEM
SRS Configuration
INFOID:0000000001396347
The air bag deploys if the air bag diagnosis sensor unit is activated while the ignition switch is in the ON or
START position.
The collision modes for which supplemental restraint systems are activated are different among the SRS sys-
tems. For example, the driver air bag module, front passenger air bag module and front seat belt pre-tension-
ers are activated in a frontal collision but not in a side collision.
SRS configurations for some collision modes are as follows:
AWHIA0001GB
SRS configuration
Frontal collision
Left side collision
Right side collision
Driver air bag module
×
—
—
Front passenger air bag module
×
—
—
Front LH seat belt pre-tensioner
×
—
—
Lap seat belt pre-tensioner
×
—
—
Front RH seat belt pre-tensioner
×
—
—
Front LH side air bag module
—
×
—
Front RH side air bag module
—
—
×
LH side curtain air bag module
—
×
—
RH side curtain air bag module
—
—
×
SRS AIR BAG SYSTEM
SRC-7
< FUNCTION DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
SRS Component Parts Location
INFOID:0000000001396420
Driver Air Bag Module
INFOID:0000000001396421
The driver air bag module is single stage and located in the steering
wheel assembly. It operates with the SRS system in a frontal colli-
sion exceeding a specified level.
1.
Crash zone sensor
2.
Spiral cable
3.
Front passenger air bag off indicator
4.
Lap seat belt pre-tensioner
5.
Front LH seat belt pre-tensioner
LH side air bag satellite sensor
(if equipped)
6.
Air bag diagnosis sensor unit
7.
Seat belt warning lamp control unit
8.
Seat belt buckle switch LH
Seat belt buckle switch RH
9.
Front RH seat belt pre-tensioner
RH side air bag satellite sensor
(if equipped)
10. Front RH side air bag module
(if equipped)
11.
Side curtain air bag modules
(if equipped)
12. Front LH side air bag module
(if equipped)
13. Passenger air bag deactivation
switch
14. Front passenger air bag module
15. Driver air bag module
AWHIA0002ZZ
WHIA0325E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст