Nissan Frontier D40. Manual — part 214
HOMELINK UNIVERSAL TRANSCEIVER
DLK-19
< FUNCTION DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
HOMELINK UNIVERSAL TRANSCEIVER
Component Description
INFOID:0000000005274491
Item
Function
Reference page
Homelink universal transceiver
A maximum of 3 radio signals can be stored and transmitted to operate
the garage door, etc.
Refer to Owner's
Manual
DLK-20
< FUNCTION DIAGNOSIS >
DIAGNOSIS SYSTEM (BCM)
DIAGNOSIS SYSTEM (BCM)
COMMON ITEM
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
INFOID:0000000005548394
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
DOOR LOCK
DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK)
INFOID:0000000005548395
WORK SUPPORT
Diagnosis mode
Function Description
WORK SUPPORT
Changes the setting for each system function.
SELF-DIAG RESULTS
Displays the diagnosis results judged by BCM. Refer to
CAN DIAG SUPPORT MNTR
Monitors the reception status of CAN communication viewed from BCM.
DATA MONITOR
The BCM input/output signals are displayed.
ACTIVE TEST
The signals used to activate each device are forcibly supplied from BCM.
ECU IDENTIFICATION
The BCM part number is displayed.
CONFIGURATION
• Enables to read and save the vehicle specification.
• Enables to write the vehicle specification when replacing BCM.
System
Sub system selection item
Diagnosis mode
WORK SUPPORT
DATA MONITOR
ACTIVE TEST
BCM
BCM
×
Door lock
DOOR LOCK
×
×
×
Rear window defogger
REAR DEFOGGER
×
×
Warning chime
BUZZER
×
×
Interior room lamp timer
INT LAMP
×
×
×
Remote keyless entry system
MULTI REMOTE ENT
×
×
×
Exterior lamp
HEAD LAMP
×
×
×
Wiper and washer
WIPER
×
×
×
Turn signal and hazard warning lamps
FLASHER
×
×
Air conditioner
AIR CONDITONER
×
Combination switch
COMB SW
×
Immobilizer
IMMU
×
×
Interior room lamp battery saver
BATTERY SAVER
×
×
×
Vehicle security system
THEFT ALM
×
×
×
RAP (retained accessory power)
RETAINED PWR
×
×
×
Signal buffer system
SIGNAL BUFFER
×
×
TPMS (tire pressure monitoring sys-
tem)
AIR PRESSURE MONITOR
×
×
×
Panic alarm system
PANIC ALARM
×
DIAGNOSIS SYSTEM (BCM)
DLK-21
< FUNCTION DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
DATA MONITOR
ACTIVE TEST
MULTIREMOTE ENT
MULTIREMOTE ENT : CONSULT-III Function (BCM - MULTIREMOTE ENT)
INFOID:0000000005548396
WORK SUPPORT
Work Item
Description
DOOR LOCK-UNLOCK SET
• ON
• OFF
ANTI-LOCK OUT SET
• ON
• OFF
AUTOMATIC DOOR LOCK SELECT
• SHIFT OUT OF P
• VH SPD
AUTOMATIC DOOR UNLOCK SE-
LECT
• MODE1: Unlock all door when IGN OFF
• MODE2: Unlock all door when out of P range
• MODE3: Unlock all door when key out
• MODE4: Unlock driver door only when IGN OFF
• MODE5: Unlock driver door only when out of P range
• MODE6: Unlock driver door only when key out
AUTOMATIC LOCK/UNLOCK SE-
LECT
• ON
• OFF
Monitor Item
[Unit}
Description
IGN ON SW [ON/OFF]
Indicates condition of ignition switch in ON position
KEY ON SW [ON/OFF]
Indicates condition of key switch
CDL LOCK SW [ON/OFF]
Indicates condition of door lock and unlock switch
CDL UNLOCK SW [ON/OFF]
Indicates condition of door lock and unlock switch
DOOR SW-DR [ON/OFF]
Indicates condition of front door switch (all) and rear door switch upper and lower (king cab) LH
DOOR SW-AS [ON/OFF]
Indicates condition of front door switch (all) and rear door switch upper and lower (king cab) RH
DOOR SW-RR [ON/OFF]
Indicates condition of rear door switch RH (crew cab)
DOOR SW-RL [ON/OFF]
Indicates condition of rear door switch LH (crew cab)
KEY CYL LK-SW [ON/OFF]
Indicates condition of lock signal from door key cylinder switch
KEY CYL UN-SW [ON/OFF]
Indicates condition of unlock signal from door key cylinder switch
KEYLESS LOCK [ON/OFF]
Indicates condition of lock signal from keyfob
KEYLESS UNLOCK [ON/OFF]
Indicates condition of unlock signal from keyfob
Test Item
Description
DOOR LOCK
This test is able to check door lock operation [ALL LCK/ALL ULK/DR UNLK/OTR ULK].
Work Item
Description
HORN CHIRP SET
Horn chirp function mode can be changed in this mode. The function mode will be changed when
"ON" or "OFF" on CONSULT-III screen is touched.
HAZARD LAMP SET
• MODE1: Nothing
• MODE2: Unlock only
• MODE3: Lock only
• MODE4: Lock and unlock
MULTI ANSWER BACK SET
Hazard and horn reminder mode can be changed in this mode. See table below for details.
DLK-22
< FUNCTION DIAGNOSIS >
DIAGNOSIS SYSTEM (BCM)
Hazard and horn reminder mode
DATA MONITOR
ACTIVE TEST
AUTO LOCK SET
• MODE1: 5 minutes
• MODE2: Nothing
• MODE3: 1 minute
PANIC ALARM SET
• MODE1: 0.5 seconds
• MODE2: Nothing
• MODE3: 1.5 seconds
PW DOWN SET
• MODE1: 2 seconds
• MODE2: Nothing
• MODE3: 5 seconds
REMO CONT ID REGIST
Keyfob ID code can be registered.
REMO CONT ID ERASUR
Keyfob ID code can be erased.
REMO CONT ID CONFIR
It can be checked whether keyfob ID code is registered or not in this mode.
MODE 1
(C mode)
MODE 2
(S mode)
Keyfob
operation
Lock
Unlock
Lock
Unlock
Hazard warning lamp flash
Twice
Once
Twice
—
Horn sound
Once
—
—
—
Work Item
Description
Monitor Item
[Unit}
Condition
IGN ON SW [ON/OFF]
Indicates condition of ignition switch in ON position
KEY ON SW [ON/OFF]
Indicates condition of key switch
ACC ON SW [ON/OFF]
Indicates condition of ignition switch in ACC position
KEYLESS LOCK [ON/OFF]
Indicates condition of lock signal from keyfob
KEYLESS UNLOCK [ON/OFF]
Indicates condition of unlock signal from keyfob
KEYLESS PANIC [ON/OFF]
Indicates condition of panic signal from keyfob
DOOR SW-DR [ON/OFF]
Indicates condition of front door switch (all) and rear door switch upper and lower (king cab) LH
DOOR SW-AS [ON/OFF]
Indicates condition of front door switch (all) and rear door switch upper and lower (king cab) RH
DOOR SW-RR [ON/OFF]
Indicates condition of rear door switch RH (crew cab)
DOOR SW-RL [ON/OFF]
Indicates condition of rear door switch LH (crew cab)
CDL LOCK SW [ON/OFF]
Indicates condition of door lock and unlock switch
CDL UNLOCK SW [ON/OFF]
Indicates condition of door lock and unlock switch
Test Item
Description
DOOR LOCK
This test is able to check door lock operation. The doors lock and unlock based on the item on CON-
SULT-III screen touched.
PW REMOTO DOWN SET
This test is able to check power window down operation. The windows are lowered when “ON” on
CONSULT-III screen is touched.
FLASHER
This test is able to check right and left hazard reminder operation. The right hazard lamp turns on
when “RH” on CONSULT-III screen is touched and the left hazard lamp turns on when "LH" on CON-
SULT-III screen is touched.
HORN
This test is able to check panic alarm and horn reminder operations. The alarm activate for 0.5 sec-
onds after “ON” on CONSULT-III screen is touched.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст