Nissan Frontier D40. Manual — part 121
BRC-182
< REMOVAL AND INSTALLATION >
[TYPE 2]
STEERING ANGLE SENSOR
STEERING ANGLE SENSOR
Removal and Installation
INFOID:0000000005548383
REMOVAL
1.
Remove the spiral cable. Refer to
SR-6, "Removal and Installation"
2.
Remove the screws and remove the steering angle sensor from the spiral cable.
INSTALLATION
Installation is in the reverse order of removal.
• Reset the neutral position of the steering angle sensor. Refer to
BRC-78, "ADJUSTMENT OF STEERING
ANGLE SENSOR NEUTRAL POSITION : Special Repair Requirement"
CAUTION:
Any time the steering angle sensor is removed and installed or replaced, you must reset the neutral
position of the steering angle sensor. Refer to
BRC-78, "ADJUSTMENT OF STEERING ANGLE SEN-
SOR NEUTRAL POSITION : Special Repair Requirement"
.
G SENSOR
BRC-183
< REMOVAL AND INSTALLATION >
[TYPE 2]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
G SENSOR
Removal and Installation
INFOID:0000000005548384
REMOVAL
1.
Remove center console rear base. Refer to
.
2.
Remove yaw rate/side/decel G sensor attaching nuts as shown.
• The location of the sensor is the same for all models.
CAUTION:
• Do not use power tools to remove or install yaw rate/side/
decel G sensor.
• Do not drop or strike the yaw rate/side/decel G sensor.
3.
Disconnect harness connector and remove the yaw rate/side/
decel G sensor.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
After performing the above work, calibrate the yaw decel G sensor. Refer to
DECEL G SENSOR : Special Repair Requirement"
WFIA0230E
BRC-184
< BASIC INSPECTION >
[TYPE 3]
APPLICATION NOTICE
BASIC INSPECTION
APPLICATION NOTICE
Application Notice
INFOID:0000000005548020
Service information
Remarks
TYPE 1
ABS
TYPE 2
VDC/TCS/ABS
TYPE 3
HILL DESCENT CONTROL/HILL START ASSIST/VDC/TCS/ABS
DIAGNOSIS AND REPAIR WORKFLOW
BRC-185
< BASIC INSPECTION >
[TYPE 3]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
INFOID:0000000005275220
PRECAUTIONS FOR DIAGNOSIS
If steering angle sensor, steering system parts, suspension system parts, ABS actuator and electric unit (con-
trol unit) or tires have been replaced, or if wheel alignment has been adjusted, be sure to adjust neutral posi-
tion of steering angle sensor before driving. Refer to
BRC-189, "ADJUSTMENT OF STEERING ANGLE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст