Nissan Frontier. Manual — part 1296
VTL-6
< PERIODIC MAINTENANCE >
IN-CABIN MICROFILTER
PERIODIC MAINTENANCE
IN-CABIN MICROFILTER
Removal and Installation
INFOID:0000000009478808
REPLACEMENT PROCEDURE
1. Open the lower glove box and press in on the sides so that it will
open completely allowing it to hang by the cord.
2. Gently lift up on the tab (1) then pull the in-cabin microfilter cover
down (2) to remove the cover (3).
CAUTION:
Use care when lifting up on the tab to avoid damaging it.
3. Remove the in-cabin microfilters from the heater and cooling unit housing.
4. Insert the first new in-cabin microfilter into the heater and cool-
ing unit housing and slide it over to the right. Insert the second
new in-cabin microfilter into the heater and cooling unit housing
as shown.
NOTE:
The in-cabin microfilters are marked with air flow arrows. The
end of the microfilter with the arrow should face the rear of the
vehicle. The arrows should point downward.
5. Install the in-cabin microfilter cover, make sure the tab is locked
in place as shown.
6. Close the lower glove box completely.
WLIA0023E
AWIIA1431ZZ
ALIIA0360ZZ
ALIIA0359ZZ
CONTROL UNIT
VTL-7
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
REMOVAL AND INSTALLATION
CONTROL UNIT
Removal and Installation
INFOID:0000000009478809
FRONT AIR CONTROL (MANUAL A/C)
Removal
1. Remove the shift selector finisher. Refer to
2. Remove the cup holder.
3. Remove cluster lid C. Refer to
IP-19, "Removal and Installation"
4. Remove the four screws securing the front air control to cluster lid C.
5. Remove the front air control.
Installation
Installation is in the reverse order of removal.
A/C AUTO AMP. (AUTOMATIC A/C)
Removal
Remove the audio unit or AV control unit. Refer to
AV-146, "Removal and Installation"
(DISPLAY AUDIO
WITHOUT AMPLIFIER),
AV-233, "Removal and Installation"
(DISPLAY AUDIO WITH AMPLIFIER) or
(NAVIGATION).
Installation
Installation is in the reverse order of removal.
VTL-8
< REMOVAL AND INSTALLATION >
IN-VEHICLE SENSOR
IN-VEHICLE SENSOR
Removal and Installation
INFOID:0000000009478810
REMOVAL
1. Remove instrument lower panel LH. Refer to
IP-18, "Removal and Installation"
.
2. Disconnect the harness connector from in-vehicle sensor.
3. Remove the two screws (A) and the in-vehicle sensor (1).
INSTALLATION
Installation is in the reverse order of removal.
ALIIA0060ZZ
OPTICAL SENSOR
VTL-9
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
OPTICAL SENSOR
Removal and Installation
INFOID:0000000009478811
REMOVAL
1. Insert a suitable tool between the optical sensor and the instrument panel, then lift the optical sensor
upward.
2. Disconnect the harness connector from the optical sensor and remove.
INSTALLATION
Installation is in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст