Nissan Pathfinder (2012 year). Manual — part 634
WW-74
< REMOVAL AND INSTALLATION >
FRONT WIPER AND WASHER SYSTEM
4. Slide retaining ring upward to release front and rear washer
motor.
5. Remove front washer motor from washer fluid reservoir.
Installation
Installation is in the reverse order of removal.
CAUTION:
When installing front washer motor, there should be no packing twists, etc.
WASHER FLUID LEVEL SENSOR
Removal
1. Remove washer fluid reservoir.
2. Lift level sensor out of washer fluid reservoir in the direction of
the arrow as shown.
Installation
Installation is in the reverse order of removal.
Washer Nozzle Adjustment
INFOID:0000000007355307
• This vehicle is equipped with non-adjustable washer nozzles.
• If not satisfied with washer fluid spray coverage, confirm that the
washer nozzle is installed correctly.
• If the washer nozzle is installed correctly, and the washer fluid
spray coverage is not satisfactory, replace the washer nozzle.
LKIA0540E
LKIA0541E
PKIA2552E
August 2012
2012 Pathfinder
REAR WIPER AND WASHER SYSTEM
WW-75
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
REAR WIPER AND WASHER SYSTEM
Removal and Installation
INFOID:0000000007355308
REAR WIPER ARM
Removal
1. Remove wiper arm cover, and remove rear wiper arm nut.
2. Remove the wiper arm.
3. Remove wiper blade from the wiper arm.
Installation
1. Operate rear wiper motor one full cycle, then turn "OFF" (Auto Stop).
2. Clean pivot area as shown. This will reduce the possibility of
wiper arm looseness.
3. Install wiper blade on the wiper arm.
4. Install wiper arm so that the arm rests in the stopper and tighten rear wiper arm nut.
5. Install wiper arm cover.
REAR WIPER MOTOR
LKIA0608E
SEL024J
August 2012
2012 Pathfinder
WW-76
< REMOVAL AND INSTALLATION >
REAR WIPER AND WASHER SYSTEM
Removal
1. Remove wiper arm. Refer to
WW-75, "Removal and Installation"
.
2. Remove pivot cap.
3. Remove rear wiper motor nut.
4. Remove rear wiper motor cover.
5. Disconnect rear wiper motor connector.
6. Remove nut and remove rear wiper motor.
7. Remove rear wiper motor cover base.
8. Remove bracket.
Installation
CAUTION:
• Do not drop the wiper motor or cause it to contact other parts.
Installation is in the reverse order of removal.
1.
Rear wiper motor cover
2.
Rear wiper motor
3.
Plate
4.
Rear wiper motor cover base
5.
Spacer
6.
Bracket
7.
Grommet
8.
Washer
9.
Rear wiper motor nut
10. Pivot cap
11. Rear wiper arm and blade
12. Wiper arm nut
13. Wiper arm cover
14. Cap nut
15. Gasket
16. Gasket
17. Stud
18. Grommet
19. Nut
AWLIA1808ZZ
LKIA0543E
August 2012
2012 Pathfinder
REAR WIPER AND WASHER SYSTEM
WW-77
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
REAR WASHER TUBE LAYOUT
NOTE:
Connect the check valve (2) to the washer fluid tube (1) so that the
directional arrow on the check valve (2) points towards the washer
nozzle tube (3).
REAR WASHER NOZZLE
Removal
1. Disconnect rear washer tube from rear washer nozzle.
2. Release retaining clips and remove washer nozzle.
Installation
Installation is in the reverse order of removal.
NOTE:
Inspect rear washer nozzle for proper spray pattern, adjust as necessary. Refer to
WASHER MOTOR
Removal
1. Remove RH front fender protector. Refer to
EXT-25, "Removal and Installation of Front Fender Protector"
.
2. Disconnect the rear washer hoses.
3. Disconnect the rear washer motor connectors.
1.
Washer fluid reservoir
2.
Washer fluid tube to rear door
3.
Rear washer nozzle
4.
Check valve
WKIA4143E
WKIA4242E
August 2012
2012 Pathfinder
WW-78
< REMOVAL AND INSTALLATION >
REAR WIPER AND WASHER SYSTEM
4. Slide retaining ring upward to release rear washer motor.
5. Remove rear washer motor from washer fluid reservoir.
Installation
Installation is in the reverse order of removal.
CAUTION:
When installing rear washer motor, there should be no packing twists, etc.
WASHER MOTOR
Rear Washer Nozzle Adjustment
INFOID:0000000007355309
• Adjust washer nozzle with suitable tool as shown in the figure.
LKIA0540E
Adjustable range
:
±
15
°
(In any direction)
LKIA0349E
WEL912A
August 2012
2012 Pathfinder
SERVICE DATA AND SPECIFICATIONS (SDS)
WW-79
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Specifications
INFOID:0000000007355310
Windshield Washer Fluid
Windshield washer fluid capacity
4.5 (1 1/4 US gal, 1 Imp gal)
Windshield washer fluid specification
Refer to
MA-18, "FOR USA AND CANADA : Fluids and Lubricants"
(United States and Canada),
MA-20, "FOR MEXICO : Fluids and Lubri-
(Mexico).
August 2012
2012 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст