Nissan Sentra. Manual — part 718
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
PWC-69
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
PWC
N
O
P
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
Diagnosis Procedure
INFOID:0000000009757291
1.
REPLACE POWER WINDOW MAIN SWITCH
• Replace power window main switch.
• Confirm the operation after replacement.
Is the result normal?
YES
>> INSPECTION END
NO
>> Check intermittent incident. Refer to
GI-39, "Intermittent Incident"
.
PWC-70
< REMOVAL AND INSTALLATION >
MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
REMOVAL AND INSTALLATION
MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Removal and Installation
INFOID:0000000009757292
REMOVAL
1. Release the pawls using a suitable tool and lift the main power window and door lock/unlock switch and
finisher as an assembly and remove.
2. Disconnect the harness connector from the main power window and door lock/unlock switch.
3. Release the four pawls (two on each side) using a suitable tool,
then separate the main power window and door lock/unlock
switch (1) from the main power window and door lock switch fin-
isher (2).
: Pawl
CAUTION:
Do not bend back the pawls on the switch finisher too far or
breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
When the main power window and door lock/unlock switch is disconnected from the harness connector it is
necessary to perform the initialization procedure. Refer to
ALKIA2814ZZ
POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH
PWC-71
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
PWC
N
O
P
POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH
Removal and Installation
INFOID:0000000009757293
REMOVAL
1. Release the pawls using a suitable tool and lift the power window and door lock/unlock switch RH and fin-
isher as an assembly and remove.
2. Disconnect the harness connector from the power window and door lock/unlock switch RH.
3. Release the four pawls (two on each side) using a suitable tool,
then separate the main power window and door lock/unlock
switch RH (1) from the main power window and door lock switch
RH finisher (2).
: Pawl
CAUTION:
Do not bend back the pawls on the switch finisher too far or
breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.
ALKIA2816ZZ
PWC-72
< REMOVAL AND INSTALLATION >
REAR POWER WINDOW SWITCH
REAR POWER WINDOW SWITCH
Removal and Installation
INFOID:0000000009757294
REMOVAL
1. Release the pawls using a suitable tool and lift the rear power window switch and finisher as an assembly
and remove
2. Disconnect the harness connector from the rear power window switch.
3. Release the pawl (one on each side) using a suitable tool, then
separate the rear power window switch (1) from the rear power
switch finisher (2).
: Pawl
CAUTION:
Do not bend back the pawls on the switch finisher too far or
breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.
ALKIA2817ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст