Nissan Sentra. Manual — part 145
BR-22
< REMOVAL AND INSTALLATION >
BRAKE PEDAL
REMOVAL AND INSTALLATION
BRAKE PEDAL
Exploded View
INFOID:0000000009756001
WITHOUT BRAKE PEDAL POSITION SWITCH
WITH BRAKE PEDAL POSITION SWITCH
1.
Snap pin
2.
Brake pedal assembly
3.
Brake pedal pad
4.
Stop lamp switch
5.
Clip
6.
Clevis pin
Apply multi-purpose grease.
AWFIA0971ZZ
BRAKE PEDAL
BR-23
< REMOVAL AND INSTALLATION >
C
D
E
G
H
I
J
K
L
M
A
B
BR
N
O
P
Removal and Installation
INFOID:0000000009756002
REMOVAL
1. Remove instrument lower panel LH. Refer to
IP-21, "Removal and Installation"
2. Remove steering column lower cover. Refer to
IP-16, "Removal and Installation"
.
3. Disconnect the harness connectors from the brake pedal position switch (if equipped) and the stop lamp
switch.
4. Rotate the stop lamp switch and the brake pedal position switch
(if equipped) (1) counter clockwise to remove.
5. Disconnect the accelerator pedal harness connector and harness clip.
6. Remove snap pin and clevis pin from clevis on brake booster.
7. Remove the brake pedal assembly.
CAUTION:
Secure the brake booster and brake master cylinder to avoid damage to components.
8. Remove accelerator pedal from brake pedal assembly. Refer to
ACC-3, "Removal and Installation"
.
1.
Snap pin
2.
Brake pedal assembly
3.
Brake pedal pad
4.
Brake pedal position switch
5.
Clip
6.
Stop lamp switch
7.
Clevis pin
Apply multi-purpose grease.
AWFIA0972ZZ
JPFIA0815ZZ
BR-24
< REMOVAL AND INSTALLATION >
BRAKE PEDAL
INSPECTION AFTER REMOVAL
Check for the following items and replace the brake pedal assembly, if necessary.
• Check the brake pedal upper rivet (A) for damage or wear.
• Check the brake pedal for bend, damage, and cracks on the
welded parts.
• Check the lapping length (D) of sub-bracket (B) and slide plate (C).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Do not reuse the clevis pin.
• Install the clevis pin in the proper direction. Refer to
• Apply multi-purpose grease to the clevis pin and the mating faces, if necessary.
ADJUSTMENT AFTER INSTALLATION
• Adjust each item of brake pedal after installing the brake pedal assembly to the vehicle. Refer to
• Perform the release position learning of the accelerator pedal. Refer to
.
Lapping length (D)
: 6.5 mm (0.256 in) or more
JSFIA0459ZZ
BRAKE PIPING
BR-25
< REMOVAL AND INSTALLATION >
C
D
E
G
H
I
J
K
L
M
A
B
BR
N
O
P
BRAKE PIPING
FRONT
FRONT : Exploded View
INFOID:0000000009756003
1.
Brake tube
2.
ABS actuator and electric unit (con-
trol unit)
3.
Connector
4.
Connector bracket
5.
Master cylinder assembly
6.
Brake booster
7.
Lock plate
8.
Brake hose
9.
Copper sealing washer
A.
To front brake hose
B.
To rear brake pipe
Front
AWFIA1071ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст