Nissan Sentra. Manual — part 54
AV-208
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO WITH BOSE]
STEERING SWITCH
STEERING SWITCH
Exploded View
INFOID:0000000009758917
Removal and Installation
INFOID:0000000009758918
REMOVAL
1. Remove the steering wheel. Refer to
ST-10, "Removal and Installation"
2. Release the pawls on the steering wheel rear finisher and remove.
3. Remove the steering switches screws (A).
4. Remove the steering switches (1) from steering wheel (2).
INSTALLATION
Installation is in the reverse order of removal.
1.
Steering wheel rear finisher
2.
Steering wheel
3.
Steering switches
Pawl
AWNIA2816ZZ
ALNIA1409ZZ
AV
ANTENNA FEEDER
AV-209
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO WITH BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ANTENNA FEEDER
Location of Antenna
INFOID:0000000009758919
Window Antenna Repair
INFOID:0000000009758920
ELEMENT CHECK
1. Attach probe circuit tester (ohm setting) to antenna terminal on
each side.
ALNIA1457ZZ
1.
M112
2.
M107
3.
Antenna feeder
4.
M141
5.
M140
6.
Satellite antenna
7.
M504
8.
M503
9.
M502
10. M500
11. M501
SEL250I
AV-210
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO WITH BOSE]
ANTENNA FEEDER
• When measuring continuity, wrap tin foil around the top of
probe. Then, press the foil against the wire with your finger.
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication
will change abruptly when probe passes the broken point.
REPAIR EQUIPMENT
• Conductive silver composition (DuPont No. 4817 or equivalent)
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
SEL122R
SEL252I
SEL253I
AV
ANTENNA FEEDER
AV-211
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO WITH BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
1. Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of
drawing pen.
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
4. After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
PIIA0215E
SEL012D
SEL013D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст