Nissan Sentra. Manual — part 227
DLK-24
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
SYSTEM (INTELLIGENT KEY SYSTEM)
SYSTEM (INTELLIGENT KEY SYSTEM)
INTELLIGENT KEY SYSTEM
INTELLIGENT KEY SYSTEM : System Description
INFOID:0000000009756351
SYSTEM DIAGRAM
SYSTEM DESCRIPTION
• The Intelligent Key system is a system that makes it possible to lock and unlock the door locks (door lock/
unlock function) by carrying the Intelligent Key, which operates based on the results of electronic ID verifica-
tion using two-way communication between the Intelligent Key and the vehicle (BCM).
NOTE:
The driver should always carry the Intelligent Key
• The settings for each function can be changed with CONSULT.
• If an Intelligent Key is lost, a new Intelligent Key can be registered. A maximum of 4 Intelligent Keys can be
registered.
• It is possible to perform a diagnosis on the system and register an Intelligent Key with CONSULT.
JMKIA7941GB
Function
Description
Refer
Door lock
Lock/unlock can be performed by pressing the request switch
Trunk open
The trunk lid can be opened by carrying the Intelligent Key and pressing the
trunk lid opener switch
SYSTEM (INTELLIGENT KEY SYSTEM)
DLK-25
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
DOOR LOCK FUNCTION
DOOR LOCK FUNCTION : System Description
INFOID:0000000009756352
SYSTEM DIAGRAM
DOOR REQUEST SWITCH OPERATION
When pressing the request switch, it is possible to lock and unlock the door by carrying the Intelligent Key.
OPERATION DESCRIPTION
• When the BCM detects that each door request switch is pressed, it starts the outside key antenna and inside
key antenna corresponding to the pressed door request switch and transmits the request signal to the Intelli-
gent Key. And then, check that the Intelligent Key is near the door.
• If the Intelligent Key is within the outside key antenna detection area, it receives the request signal and
transmits the key ID signal to the BCM via remote keyless entry receiver.
• BCM receives the key ID signal and compares it with the registered key ID.
• BCM transmits door lock/unlock signal and operates each door lock actuator. At the same time, BCM blinks
hazard warning lamp (lock: 1 time, unlock: 2 times) and sounds Intelligent Key buzzer (lock: 1 time, unlock:
2 times) as a reminder.
OPERATION CONDITION
If the following conditions are satisfied, door lock/unlock operation is performed if the door request switch is
operated.
Remote keyless entry
Lock/unlock can be performed by pressing the remote controller button of the
Intelligent Key
Key reminder
The key reminder buzzer sounds a warning if the door is locked with the key left
inside the vehicle
Warning
If an action that does not meet the operating condition of the Intelligent Key sys-
tem is taken, the buzzer sounds to inform the driver
Engine start
The engine can be turned on while carrying the Intelligent Key
Interior room lamp control
Interior room lamp is controlled according to door lock/unlock state
Function
Description
Refer
JMKIA6137GB
DLK-26
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
SYSTEM (INTELLIGENT KEY SYSTEM)
*: Even with a registered Intelligent Key remaining inside the vehicle, door locks can be unlocked from outside of the vehicle with a spare
Intelligent Key as long as key IDs are different.
Door lock function can be changed using “LOCK/UNLOCK BY I-KEY” mode in “WORK SUPPORT”. Refer to
DLK-36, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
OUTSIDE KEY ANTENNA DETECTION AREA
The outside key antenna detection area of door lock/unlock function
is in the range of approximately 80 cm (31.50 in) surrounding the
driver, passenger door handles (1). However, this operating range
depends on the ambient conditions.
HAZARD AND BUZZER REMINDER FUNCTION
For the operation check, BCM blinks hazard warning lamps (lock: 1 time, unlock: 2 times) and sounds Intelli-
gent Key warning buzzer (lock: 1 time, unlock: 2 times) when door lock or unlock operates by operation of
each door request switch.
How to Change Hazard and Buzzer Reminder Mode
DLK-36, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
AUTO DOOR LOCK FUNCTION
After door is unlocked by door request switch operation and if 30 seconds or more passes without performing
the following operation, all doors are automatically locked. However, operation check function does not acti-
vate.
Auto door lock mode can be changed by the “AUTO LOCK SET” mode in “WORK SUPPORT”. Refer to
36, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
LIST OF OPERATION RELATED PARTS
Parts marked with
× are the parts related to operation.
Each request switch operation
Operation condition
Lock
• All doors are closed
• Ignition switch is in the LOCK or OFF position
• Panic alarm is not activated
• Intelligent Key is outside the vehicle
• Intelligent Key is within outside key antenna detection area
• P position warning is not activated
Unlock
• All doors are closed
• Ignition switch is in the LOCK or OFF position
• Panic alarm is not activated
• Intelligent Key is outside the vehicle
• Intelligent Key is within outside key antenna detection area *
JMKIA4881ZZ
Operating condition
• Door switch is ON (door is open)
• BCM receives lock signal
• Push switch is pressed
SYSTEM (INTELLIGENT KEY SYSTEM)
DLK-27
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
TRUNK OPEN FUNCTION
TRUNK OPEN FUNCTION : System Description
INFOID:0000000009756353
System Diagram
TRUNK LID OPENER OPERATION
• When the BCM detects that trunk lid opener switch is pressed, it starts the outside key antenna (rear
bumper) and inside key antenna and transmits the request signal to the Intelligent Key. Then, checks that
the Intelligent Key is near the trunk lid.
• If the Intelligent Key is within the outside key antenna detection area, it receives the request signal and
transmits the key ID signal to the BCM via remote keyless entry receiver.
• BCM receives the key ID signal and compares it with the registered key ID.
OPERATION CONDITION
If the following conditions are satisfied, the trunk lid can be opened.
OUTSIDE KEY ANTENNA DETECTION AREA
Door lock function
In
te
llige
nt
Key
Re
mo
te
ke
yl
es
s en
try rec
ei
ve
r
Do
or swit
ch
Do
or requ
es
t swit
ch
Do
or loc
k ac
tu
ato
r
In
si
de
ke
y an
ten
n
a
Out
si
de ke
y a
n
ten
n
a
In
te
llige
nt
Key
wa
rnin
g
bu
zz
er
CAN co
mm
un
ic
ati
on
s
ys
tem
BC
M
Hazard w
a
rning
lamp
P
us
h-b
utt
on ig
nit
ion
s
w
itc
h
Combination meter
Door lock/unlock function
×
×
×
×
×
×
×
×
Hazard and buzzer reminder function
×
×
×
×
×
Auto door lock function
×
×
×
×
×
×
×
×
JMKIA7942GB
Trunk lid open function
Operation condition
Trunk open operation
• Vehicle speed is less than 5 km/h (3 MPH)
• Intelligent Key is within outside key antenna (rear bumper) detection area
• Trunk lid is closed
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст