Nissan Cube. Manual — part 81
BRAKE PEDAL
BR-17
< REMOVAL AND INSTALLATION >
C
D
E
G
H
I
J
K
L
M
A
B
BR
N
O
P
REMOVAL AND INSTALLATION
BRAKE PEDAL
Exploded View
INFOID:0000000009949211
WITH ASCD
WITHOUT ASCD
1.
Clevis pin
2.
Brake pedal assembly
3.
Brake pedal pad
4.
ASCD brake switch
5.
Clip
6.
Stop lamp switch
7.
Snap pin
: Apply multi-purpose grease.
Refer to
for symbols not described on the above.
JPFIA0541GB
BR-18
< REMOVAL AND INSTALLATION >
BRAKE PEDAL
Removal and Installation
INFOID:0000000009949212
REMOVAL
1.
Remove instrument lower panel LH. Refer to
2.
Remove knee protector. Refer to
ST-11, "Removal and Installation"
3.
Disconnect the stop lamp switch and ASCD brake switch (with ASCD) harness connectors.
4.
Disconnect the accelerator pedal harness connector and clip.
5.
Remove snap pin and clevis pin from clevis.
6.
Remove the brake pedal assembly.
7.
Remove accelerator pedal from brake pedal assembly. Refer to
.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been
already applied)
NOTE:
The clevis pin may be inserted in either direction.
Inspection and Adjustment
INFOID:0000000009949213
INSPECTION AFTER REMOVAL
• Check for the following items and replace the brake pedal assembly if necessary.
1.
Clevis pin
2.
Brake pedal assembly
3.
Brake pedal pad
4.
Stop lamp switch
5.
Clip
6.
Snap pin
: Apply multi-purpose grease.
Refer to
for symbols not described on the above.
JPFIA0540GB
BRAKE PEDAL
BR-19
< REMOVAL AND INSTALLATION >
C
D
E
G
H
I
J
K
L
M
A
B
BR
N
O
P
- Check the brake pedal upper rivet (made by aluminum) (A) for
deformation.
- Check the brake pedal for bend, damage, and cracks on the
welded parts.
- Check the lapping length (X) of sub-bracket (B) and slide plate (C).
• Check clevis pin and plastic stopper (A) for damage and deforma-
tion. If any is found, replace clevis pin.
ADJUSTMENT AFTER INSTALLATION
• Adjust each item of brake pedal after installing the brake pedal assembly to the vehicle. Refer to
.
• Perform the release position learning of the accelerator pedal. Refer to
RELEASED POSITION LEARNING : Special Repair Requirement"
Standard
X
: 6.5 mm (0.256 in) or more
PFIA0755J
PFIA0756J
BR-20
< REMOVAL AND INSTALLATION >
BRAKE PIPING
BRAKE PIPING
FRONT
FRONT : Exploded View
INFOID:0000000009949214
1.
Brake tube
2.
ABS actuator and electric unit (con-
trol unit)
3.
Connector
4.
Connector bracket
5.
Master cylinder
6.
Brake booster
7.
Lock plate
8.
Brake hose
9.
Union bolt
10. Copper washer
A.
To front brake hose
B.
To rear brake tube
Refer to
for symbols in the figure.
JPFIA0542GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст