Nissan Cube. Manual — part 1079
REAR WIPER ARM
WW-153
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
Standard clearance
L
: 54.5
±
7.5 mm (2.146
±
0.295 in)
JPLIA1821ZZ
WW-154
< REMOVAL AND INSTALLATION >
REAR WIPER MOTOR
REAR WIPER MOTOR
Exploded View
INFOID:0000000009945890
Removal and Installation
INFOID:0000000009945891
REMOVAL
1.
Remove rear wiper arm cover and rear wiper arm. Refer to
.
2.
Remove back door finisher lower. Refer to
.
3.
Disconnect the rear wiper motor connector.
4.
Remove rear wiper motor mounting bolts.
5.
Remove rear wiper motor from the vehicle.
6.
Remove pivot seal.
INSTALLATION
1.
Install the pivot seal.
2.
Install the rear wiper motor to the vehicle.
3.
Connect the rear wiper motor connector.
4.
Operate the rear wiper to the auto stop position.
5.
Install the back door finisher lower. Refer to
6.
Install rear wiper arm cover and rear wiper arm. Refer to
.
1.
Rear wiper motor
2.
Rear wiper blade
3.
Rear wiper arm
4.
Rear wiper arm cover
5.
Pivot seal
Refer to
for symbols in the figure.
JPLIA1820GB
REAR WASHER NOZZLE AND TUBE
WW-155
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
REAR WASHER NOZZLE AND TUBE
Hydraulic Layout
INFOID:0000000009945892
Removal and Installation
INFOID:0000000009945893
REMOVAL
1.
Remove the back door finisher upper. Refer to
1.
Rear washer nozzle
2.
Rear washer tube
3.
Washer tank
: Clip
: Grommet
JPLIA1767ZZ
WW-156
< REMOVAL AND INSTALLATION >
REAR WASHER NOZZLE AND TUBE
2.
Remove the rear washer tube from the rear washer nozzle (1).
3.
Push pawl (A), and remove the rear washer nozzle from the
back door.
INSTALLATION
Install in the reverse order of removal.
Inspection and Adjustment
INFOID:0000000009945894
INSPECTION
Washer Nozzle Inspection
Check that air can pass through the hose by blowing forward (toward
the nozzle), and check that air cannot pass through by sucking.
ADJUSTMENT
Washer Nozzle Spray Position adjustment
Adjust spray positions to match the positions shown in the figure.
Unit: mm (in)
Insert a needle or similar object (A) into the spray opening (1) and
move up/down and left/right to adjust the spray position.
NOTE:
If wax or dust gets into the nozzle, remove wax or dust with a needle
or small pin.
JPLIA1740ZZ
JPLIA1659ZZ
1
: Black printed frame line
Spray position
H : Height
L : Length
φ
: Spray position area
A
1 (0.04)
164.8 (6.49)
30 (1.18)
JPLIA1822ZZ
JPLIA1661ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст