Nissan Cube. Manual — part 121
CORROSION PROTECTION
BRM-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
: Vehicle front
: Sealed portions
JSKIA1185ZZ
BRM-18
< REMOVAL AND INSTALLATION >
BODY CONSTRUCTION
BODY CONSTRUCTION
Body Construction
INFOID:0000000009949333
1.
Outer side body
2.
Outer front pillar reinforcement
3.
Upper inner front pillar
4.
Upper hinge plate
5.
Hoodledge reinforcement
6.
Side dash
7.
Cowl top
8.
Cowl top stay
9.
Upper dash
JSKIA1186ZZ
BODY CONSTRUCTION
BRM-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Rear Fender Hemming Process
INFOID:0000000009949334
1.
A wheel arch is to be installed and hemmed over the left and right outer wheel houses.
2.
In order to hem the wheel arch, it is necessary to repair any damaged or defaced parts around outer
wheel house.
CAUTION:
Ensure that the area that is to be glued around the outer wheelhouse is undamaged or defaced.
PROCEDURE OF THE HEMMING PROCESS
• Peel off old bonding material on the surface of the outer wheel-
house and clean thoroughly.
• Peel off a primer coat in the specified area where new adhesive is
to be applied on rear fender (the replacing part).
• Apply new adhesive to both specified areas of the outer wheel-
house and rear fender.
• Attach rear fender to the body of the car, and weld the required
part except the hemming part.
• Bend the welded part starting from the center of the wheel arch
gradually with a hammer and a dolly. (Also hem the end of the
flange.)
• Hemming with a hammer is conducted to an approximate angle of
80 degrees.
• Starting from the center, hem the wheel arch gradually, using slight
back and forth motion with a hemming tool.
10. Inner front pillar reinforcement
11.
Weld nut
12. Lower front pillar hinge brace
13. Lower hinge plate
14. Lower dash
15. Inner front pillar reinforcement
16. Outer sill reinforcement
17. Lower front pillar reinforcement
18. Inner sill
19. Front outrigger
20. Front floor
21. Front floor reinforcement
22. Inner sill reinforcement
23. Inner sill
24. 2nd crossmember
25. Outer front seat mount bracket
26. Outer front seat mount front rein-
forcement
27. Center pillar reinforcement
28. Lower lock pillar reinforcement
29. Inner center pillar
30. Outer sill brace
31. Inner rear wheelhouse
32. Outer rear wheelhouse
33. Rear pillar seat belt anchor
34. Inner rear pillar
35. Back pillar reinforcement
36. Lower outer back pillar
37. Upper hinge brace
<Adhesive>
3M™ Automix™ Panel Bonding Adhe-
sive 08115 or equivalent
JSKIA0136GB
SIIA2245E
SIIA2246E
BRM-20
< REMOVAL AND INSTALLATION >
BODY CONSTRUCTION
• Seal up the area around the hemmed end of the flange.
JSKIA0137GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст