Nissan Cube. Manual — part 656
OIL PUMP
LU-13
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
Removal and Installation
INFOID:0000000009950384
REMOVAL
1.
Remove oil pan (lower). Refer to
2.
Remove front cover, and other related parts. Refer to
3.
Remove oil pump sprocket with the following procedure:
• Add matching mark if necessary for easier installation.
a.
Press stopper tab (A) in the direction shown in the figure to push
the oil pump chain tensioner slack guide (B) toward oil pump
chain tensioner (1).
• The oil pump chain tensioner slack guide is released by press-
ing the stopper tab. As the result, the oil pump chain tensioner
slack guide can be moved.
b.
Insert a stopper pin (D) into tensioner body hole (C) to secure
the oil pump chain tensioner slack guide.
NOTE:
Use a hard metal pin with the diameter of approximately 1.2 mm
(0.047 in) as a stopper pin.
c.
Remove oil pump chain tensioner.
• When the holes on lever and tensioner body cannot be
aligned, align these holes by slightly moving the oil pump
chain tensioner slack guide.
d.
Hold the WAF part of oil pump shaft [WAF: 10 mm (0.39 in)] (A),
and then loosen the oil pump sprocket bolt and remove it.
CAUTION:
• Secure the oil pump shaft with the WAF part.
• Never loosen the oil pump sprocket bolt by tightening the
oil pump drive chain.
e.
Remove oil pump sprocket.
4.
Remove oil pump.
PBIC5314E
1
: Oil pan (upper)
2
: Oil pump
: Engine front
PBIC3539J
LU-14
< REMOVAL AND INSTALLATION >
OIL PUMP
• Loosen bolts in reverse order as shown in the figure.
INSTALLATION
Note the following, and install in the reverse order of removal.
Oil Pump
• Tighten bolts in numerical order as shown in the figure.
Inspection
INFOID:0000000009950385
INSPECTION AFTER INSTALLATION
1.
Check the engine oil level. Refer to
.
2.
Start the engine, and check that there is no leakage of engine oil.
3.
Stop the engine and wait for 10 minutes.
4.
Check the engine oil level, and adjust the level. Refer to
.
1
: Oil pump
2
: Oil pan (upper)
: Engine front
PBIC3532J
1
: Oil pump
2
: Oil pan (upper)
: Engine front
PBIC3532J
SERVICE DATA AND SPECIFICATIONS (SDS)
LU-15
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Periodical Maintenance Specification
INFOID:0000000009950386
ENGINE OIL CAPACITY (APPROXIMATE)
Unit:
(US qt, lmp qt)
Engine Oil Pressure
INFOID:0000000009950387
Unit: kPa (kg/cm
2
, psi)
*: Engine oil temperature at 80
°
C (176
°
F)
Drain and refill
With oil filter change
4.1 (4-3/8, 3-5/8)
Without oil filter change
3.8 (4, 3-3/8)
Dry engine (Overhaul)
4.9 (5-1/8, 4-3/8)
Engine speed
Approximate discharge pressure*
Idle speed
60 (0.61, 9)
2,000 rpm
200 (2.0, 29)
MA-1
MAINTENANCE
C
D
E
F
G
H
I
J
K
L
M
B
MA
SECTION
MA
N
O
A
CONTENTS
MAINTENANCE
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ...
Special Service Tool . . . . . . . . . . . .....
Commercial Service Tool . . . . . . . . . . ..
PERIODIC MAINTENANCE . . . . . . ..
GENERAL MAINTENANCE . . . . . . . .
Explanation of General Maintenance . . . . . ....
PERIODIC MAINTENANCE . . . . . . . .
Introduction of Periodic Maintenance . . . . . ....
RECOMMENDED FLUIDS AND LUBRI-
CANTS . . . . . . . . . . . . . . . .
Fluids and Lubricants . . . . . . . . . . . ..
Engine Oil Recommendation . . . . . . . . ..
Anti-Freeze Coolant Mixture Ratio . . . . . . ..
ENGINE MAINTENANCE . . . . . . . . ...
DRIVE BELT . . . . . . . . . . . . . . . ..
DRIVE BELT : Exploded View . . . . . . . .
DRIVE BELT : Checking . . . . . . . . . . .
DRIVE BELT : Tension Adjustment . . . . . .
ENGINE COOLANT . . . . . . . . . . . . ...
ENGINE COOLANT : Draining . . . . . . . .
ENGINE COOLANT : Refilling . . . . . . . .
ENGINE COOLANT : Flushing . . . . . . . ...
FUEL LINES . . . . . . . . . . . . . . . ..
FUEL LINES : Inspection . . . . . . . . . .
AIR CLEANER FILTER . . . . . . . . . . . .
AIR CLEANER FILTER : Removal and Installation
.
AIR CLEANER FILTER : Inspection (Viscous Pa-
per Type) . . . . . . . . . . . . . . . . .
ENGINE OIL . . . . . . . . . . . . . . . ..
ENGINE OIL : Draining . . . . . . . . . . ...
ENGINE OIL : Refilling . . . . . . . . . . .
OIL FILTER . . . . . . . . . . . . . . . .
OIL FILTER : Removal and Installation . . . . ...
OIL FILTER : Inspection . . . . . . . . . . ..
SPARK PLUG . . . . . . . . . . . . . . .
SPARK PLUG : Removal and Installation . . . ...
SPARK PLUG : Inspection . . . . . . . . . ..
EVAP VAPOR LINES . . . . . . . . . . . .
EVAP VAPOR LINES : Inspection . . . . . . ...
CHASSIS MAINTENANCE . . . . . . . ...
EXHAUST SYSTEM . . . . . . . . . . . . ...
EXHAUST SYSTEM : Inspection . . . . . . .
CVT FLUID . . . . . . . . . . . . . . . . .
CVT FLUID : Inspection . . . . . . . . . . ...
CVT FLUID : Changing . . . . . . . . . . .
GEAR OIL . . . . . . . . . . . . . . . . ..
GEAR OIL : Inspection . . . . . . . . . . .
GEAR OIL : Draining . . . . . . . . . . . ...
GEAR OIL : Refilling . . . . . . . . . . . .
CLUTCH FLUID . . . . . . . . . . . . . . .
CLUTCH FLUID : Inspection . . . . . . . . ...
WHEELS (BONDING WEIGHT TYPE) . . . . . ..
WHEELS (BONDING WEIGHT TYPE) : Adjust-
ment . . . . . . . . . . . . . . . . . . .
BRAKE FLUID LEVEL AND LEAKS . . . . . . .
BRAKE FLUID LEVEL AND LEAKS : Inspection .
BRAKE LINES AND CABLES . . . . . . . . ...
BRAKE LINES AND CABLES : Inspection . . . ..
BRAKE FLUID . . . . . . . . . . . . . . ...
BRAKE FLUID : Changing . . . . . . . . . ...
DISC BRAKE . . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст