Nissan Cube. Manual — part 659
MA-10
< PERIODIC MAINTENANCE >
RECOMMENDED FLUIDS AND LUBRICANTS
RECOMMENDED FLUIDS AND LUBRICANTS
Fluids and Lubricants
INFOID:0000000009949415
*1: For additional information, see “Engine Oil Recommendation”.
*2: Use only Genuine NISSAN CVT Fluid NS-2. Using transmission fluid other than Genuine NISSAN CVT Fluid NS-2 will damage the
CVT, which is not covered by the NISSAN new vehicle limited warranty.
*3: If Genuine NISSAN Manual Transmission Fluid (MTF) TL/JR Type is not available, API GL-4+, Viscosity SAE 75W-80 may be used
as a temporary replacement. However, use Genuine NISSAN Manual Transmission Fluid (MTF) TL/JR Type as soon as it is available.
*4: Available in mainland U.S.A. through a NISSAN dealer.
Engine Oil Recommendation
INFOID:0000000009949416
NISSAN recommends the use of an energy conserving oil in order to improve fuel economy.
Select only engine oils that meet the American Petroleum Institute (API) certification and International Lubri-
cant Standardization and Approval Committee (ILSAC) certification and SAE viscosity standard. These oils
have the API certification mark on the front of the container. Oils which do not have the specified quality label
should not be used as they could cause engine damage.
Capacity (Approximate)
Recommended Fluids/Lubricants
US measure
Imp mea-
sure
Liter
Engine oil
Drain and refill
With oil filter change
4-3/8 qt
3-5/8 qt
4.1
Genuine NISSAN engine oil or equiv-
alent
Engine oil with API Certification
Mark*
1
Viscosity SAE 5W-30
Without oil filter change
4 qt
3-3/8 qt
3.8
Dry engine (Overhaul)
5-1/8 qt
4-3/8 qt
4.9
Cooling system
With reservoir
tank
CVT models
7-1/2 qt
6-1/4 qt
7.1
Pre-diluted Genuine NISSAN Long
Life Antifreeze/Coolant (blue) or
equivalent
M/T models
7-1/4 qt
6 qt
6.8
Reservoir tank
3/4 qt
5/8 qt
0.7
CVT fluid
7-7/8 qt
6-1/2 qt
7.4
Genuine NISSAN CVT Fluid NS-2 *
2
Manual transaxle gear oil
4-1/4 pt
3-1/2 pt
2.0
Genuine NISSAN Manual Transmis-
sion Fluid (MTF) TL/JR Type 75W-80,
or equivalent *
3
Brake and clutch fluid
—
—
—
Genuine NISSAN Super Heavy Duty
Brake Fluid*
4
or equivalent DOT 3
(US FMVSS No. 116)
Multi-purpose grease
—
—
—
NLGI No. 2 (Lithium soap base)
Windshield washer fluid
—
—
—
Genuine NISSAN Windshield Washer
Concentrate Cleaner & Antifreeze or
equivalent
Fuel recommendation
—
—
—
Refer to
1.
API certification mark
2.
API service symbol
JSPIA0014ZZ
RECOMMENDED FLUIDS AND LUBRICANTS
MA-11
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
M
B
MA
N
O
A
Anti-Freeze Coolant Mixture Ratio
INFOID:0000000009949417
The engine cooling system is filled at the factory with a pre-diluted mixture of 50% Genuine NISSAN Long Life
Antifreeze/Coolant (blue) and 50% water to provide year-round anti-freeze and coolant protection. The anti-
freeze solution contains rust and corrosion inhibitors. Additional engine cooling system additives are not nec-
essary.
WARNING:
• Never remove the radiator or coolant reservoir cap when the engine is hot. Wait until the engine and
radiator cool down. Serious burns could be caused by high pressure fluid escaping from the radia-
tor.
• The radiator is equipped with a pressure type radiator cap. To prevent engine damage, use only a
genuine NISSAN radiator cap.
CAUTION:
• When adding or replacing coolant, be sure to use only Genuine NISSAN Long Life Antifreeze/Cool-
ant (blue) or equivalent. Genuine NISSAN Long Life Antifreeze/Coolant (blue) is pre-diluted to pro-
vide antifreeze protection to -34
°
F (-37
°
C). If additional freeze protection is needed due to weather
where you operate your vehicle, add Genuine NISSAN Long Life Antifreeze/Coolant (blue) concen-
trate following the directions on the container. If an equivalent coolant other than Genuine NISSAN
Long Life Antifreeze/Coolant (blue) is used, follow the coolant manufactur's instructions to maintain
minimum antifreeze protection to -34
°
F (-37
°
C). The use of other types of coolant solutions other
than Genuine NISSAN Long Life Antifreeze/Coolant (blue) or equivalent may damage the engine
cooling system.
• Mixing any other type of coolant other than Genuine NISSAN Long Life Antifreeze/Coolant (blue),
including Genuine NISSAN Long Life Antifreeze/Coolant (green), or the use of non-distilled water will
reduce the life expectancy of the factory-fill coolant.
MA-12
< PERIODIC MAINTENANCE >
ENGINE MAINTENANCE
ENGINE MAINTENANCE
DRIVE BELT
DRIVE BELT : Exploded View
INFOID:0000000009949418
DRIVE BELT : Checking
INFOID:0000000009949419
WARNING:
Perform this step when engine is stopped.
• Check that the indicator (C) (notch on fixed side) of drive belt auto-tensioner is within the possible use range
(A) in the figure.
NOTE:
• Check the drive belt auto-tensioner indication when the engine is cold.
• When new drive belt is installed, the indicator (notch on fixed side) should be within the range (B) in the fig-
ure.
• Visually check entire drive belt for wear, damage or cracks.
• If the indicator (notch on fixed side) is out of the possible use range or belt is damaged, replace drive belt.
DRIVE BELT : Tension Adjustment
INFOID:0000000009949420
ENGINE COOLANT
ENGINE COOLANT : Draining
INFOID:0000000009949421
WARNING:
• Never remove radiator cap when engine is hot. Serious burns may occur from high-pressure engine
coolant escaping from radiator.
• Wrap a thick cloth around the radiator cap. Slowly turn it a quarter of a turn to release built-up pres-
sure. Then turn it all the way.
1.
Remove engine under cover.
1.
Alternator
2.
Drive belt auto-tensioner
3.
Crankshaft pulley
4.
A/C compressor (models with A/C)
Idler pulley (models without A/C)
5.
Water pump
6.
Drive belt
A.
Possible use range
B.
Range when new drive belt is in-
stalled
C.
Indicator
PBIC3137J
Refer to
.
ENGINE MAINTENANCE
MA-13
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
M
B
MA
N
O
A
2.
Open radiator drain plug (A) at the bottom of radiator, and then
remove radiator cap.
CAUTION:
Perform this step when engine is cold.
• When draining all of engine coolant in the system, open water
drain plugs on cylinder block. Refer to
3.
Remove reservoir tank if necessary, and drain engine coolant and clean reservoir tank before installing.
Refer to
4.
Check drained engine coolant for contaminants such as rust, corrosion or discoloration. If contaminated,
flush the engine cooling system. Refer to
MA-14, "ENGINE COOLANT : Flushing"
ENGINE COOLANT : Refilling
INFOID:0000000009949422
CAUTION:
• Do not reuse O-rings.
• Do not put additive such as waterleak preventive, since it may cause cooling waterway clogging.
• When refilling use Genuine NISSAN Long Life Antifreeze/Coolant (blue) or equivalent in its quality
mixed with water (distilled or demineralized). Refer to
MA-10, "Fluids and Lubricants"
1.
Install reservoir tank if removed and radiator drain plug.
CAUTION:
Be sure to clean drain plug and install with new O-ring.
• If water drain plugs on cylinder block are removed, close and tighten them. Refer to
.
2.
Check that each hose clamp has been firmly tightened.
3.
Remove air duct (between air cleaner case and electric throttle control actuator). Refer to
4.
Disconnect heater hose (1) at position (
) in the figure.
• Enhance heater hose as high as possible.
5.
Fill radiator (1) to specified level.
CAUTION:
Never adhere the engine coolant to electronic equipments
(alternator etc.).
• Pour coolant slowly of less than 2 (2-1/8 US qt, 1-3/4
Imp qt) a minute to allow air in system to escape.
• When engine coolant overflows disconnected heater
hose, connect heater hose, and continue filling the engine
cooling system.
: Vehicle front
KBIA4314J
Radiator drain plug
: Refer to
: Vehicle front
PBIC3802E
JPBIA0819ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст