Nissan Cube. Manual — part 625
PRECAUTIONS
INT-9
< PRECAUTION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
Precautions for Removing of Battery Terminal
INFOID:0000000010089665
• When removing the 12V battery terminal, turn OFF the ignition
switch and wait at least 30 seconds.
NOTE:
ECU may be active for several tens of seconds after the ignition
switch is turned OFF. If the battery terminal is removed before ECU
stops, then a DTC detection error or ECU data corruption may
occur.
• For vehicles with the 2-batteries, be sure to connect the main bat-
tery and the sub battery before turning ON the ignition switch.
NOTE:
If the ignition switch is turned ON with any one of the terminals of
main battery and sub battery disconnected, then DTC may be
detected.
• After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.
NOTE:
The removal of 12V battery may cause a DTC detection error.
Precaution for Work
INFOID:0000000009949260
• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their
operation.
• Check the lubrication level, damage, and wear of each part. If necessary, grease or replace it.
SEF289H
INT-10
< PREPARATION >
PREPARATION
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000009949261
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
INFOID:0000000009949262
Tool number
(Kent-Moore No.)
Tool name
Description
(J-39570)
Chassis ear
Locates the noise
(J-50397)
NISSAN Squeak and Rattle
Kit
Repairs the cause of noise
SIIA0993E
SIIA0994E
Tool name
Description
Engine ear
Locates the noise
Remover tool
Removes clips, pawls and metal clips
Power tool
Loosening bolts, nuts and screw
SIIA0995E
JMKIA3050ZZ
PIIB1407E
CLIP LIST
INT-11
< PREPARATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
CLIP LIST
Clip List
INFOID:0000000009949263
JMJIA3734GB
INT-12
< REMOVAL AND INSTALLATION >
FRONT DOOR FINISHER
REMOVAL AND INSTALLATION
FRONT DOOR FINISHER
Exploded View
INFOID:0000000009949264
Removal and Installation
INFOID:0000000009949265
CAUTION:
• Wrap the tips of flat-bladed screwdriver with shop cloth before removal.
• When removing, always use a remover tool that is made of plastic.
REMOVAL
1.
Fully open door window.
2.
Remove corner cover. Refer to
MIR-16, "DOOR MIRROR ASSEMBLY : Removal and Installation"
.
1.
Front door panel
2.
Front door inside handle
3.
Power window main switch finisher
4.
Front door finisher
5.
Power window main switch finisher
bracket
: Clip
: Pawl
: Metal clip
JMJIA3022ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст