Nissan Cube. Manual — part 843
VEHICLE SECURITY SYSTEM
SEC-183
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
• When the vehicle security system is in the disarmed phase, the security indicator lamp blinks every 2.4 sec-
onds.
Pre-armed Phase and Armed Phase
When the following operation 1 or 2 is performed, the vehicle security system turns into the “pre-armed”
phase. (Security indicator lamp illuminates.)
1.
BCM receives LOCK signal from door key cylinder switch, door lock and unlock switch or keyfob, after all
doors are closed.
2.
All doors are closed after all doors are locked by ignition key or door lock and unlock switch.
CANCELING THE ARMED PHASE VEHICLE SECURITY SYSTEM
When one of the following operations is performed, the armed phase is canceled.
1.
Unlock all doors ignition key, door lock and unlock switch or keyfob.
2.
Turn ignition switch “ON” position.
CANCELING THE ALARM OPERATION OF THE VEHICLE SECURITY SYSTEM
When one of the following operations is performed, the alarm operation is canceled.
1.
Unlock all doors with the keyfob.
2.
Turn ignition switch “ON” position.
ACTIVATING THE ALARM OPERATION OF THE VEHICLE SECURITY SYSTEM
Check that the system is in the armed phase. (Security indicator lamp blinks every 2.4 seconds.)
When the following operation 1 or 2 is performed, the system sounds the horns and blinks the headlamps for
approx. 50 seconds.
1.
Any door is opened during armed phase.
2.
Disconnecting and connecting the battery connector before canceling armed phase.
PANIC ALARM OPERATION
When BCM receives panic alarm signal from keyfob, ground is supplied intermittently to both headlamp relay
and horn relay.
When headlamp relay and horn relay are energized, then power is supplied to headlamps (HI) and horn.
The headlamp blinks and the horn sounds intermittently.
The alarm automatically turns off after 50 seconds or when BCM receives any signal from keyfob.
SEC-184
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
VEHICLE SECURITY SYSTEM
Component Parts Location
INFOID:0000000009950246
Component Description
INFOID:0000000009950247
1.
Security indicator lamp
(combination meter M34)
2.
NATS antenna amp. M26
3.
Remote keyless entry tuner M61
4.
Clutch interlock switch E113
(with M/T)
5.
Horn E50, E51
6.
Transmission range switch F21
(with CVT)
7.
IPDM E/R
E10, E11, E12, E13, E14, E15
8.
ECM E16
9.
BCM
M65, M66, M67
10.
Front door switch (driver side) B34
A.
Behind steering column cover
B.
Behind instrument lower panel LH
JMKIA4035ZZ
Component Reference
BCM
Security indicator lamp
Door switch
Horn
Headlamp
DIAGNOSIS SYSTEM (BCM)
SEC-185
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
DIAGNOSIS SYSTEM (BCM)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
INFOID:0000000010246095
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
×
: Applicable item
IMMU
IMMU : CONSULT Function (BCM - IMMU)
INFOID:0000000009950249
DATA MONITOR
NOTE:
Diagnosis mode
Function Description
Work Support
Changes the setting for each system function.
Self Diagnostic Result
Displays the diagnosis results judged by BCM.
CAN Diag Support Monitor
Monitors the reception status of CAN communication viewed from BCM.
Data Monitor
The BCM input/output signals are displayed.
Active Test
The signals used to activate each device are forcibly supplied from BCM.
Ecu Identification
The BCM part number is displayed.
Configuration
• Read and save the vehicle specification.
• Write the vehicle specification when replacing BCM.
System
Sub system selection item
Diagnosis mode
Work Support
Data Monitor
Active Test
Door lock
DOOR LOCK
×
×
×
Rear window defogger
REAR DEFOGGER
×
×
Warning chime
BUZZER
×
×
Interior room lamp control
INT LAMP
×
×
×
Remote keyless entry system
MULTI REMOTE ENT
×
×
×
Exterior lamp
HEAD LAMP
×
×
×
Wiper and washer
WIPER
×
×
×
Turn signal and hazard warning lamps
FLASHER
×
×
Manual air conditioner
AIR CONDITONER
×
×
Combination switch
COMB SW
×
Body control system
BCM
×
NVIS - NATS
IMMU
×
×
×
Interior room lamp battery saver
BATTERY SAVER
×
×
×
Back door
TRUNK
×
Vehicle security system
THEFT ALM
×
×
×
RAP system
RETAINED PWR
×
×
Signal buffer system
SIGNAL BUFFER
×
×
TPMS
TPMS (AIR PRESSURE MONITOR)
×
×
×
Panic alarm system
PANIC ALARM
×
SEC-186
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
DIAGNOSIS SYSTEM (BCM)
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.
ACTIVE TEST
THEFT ALM
THEFT ALM : CONSULT Function (BCM - THEFT ALM)
INFOID:0000000009950250
DATA MONITOR
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.
WORK SUPPORT
Monitor item
Content
IGN ON SW
Indicates [ON/OFF] condition of ignition switch in ON position.
KEY ON SW
Indicates [ON/OFF] condition of key switch.
Test item
Description
THEFT IND
This test is able to check security indicator lamp operation [ON/OFF].
Monitor Item
Condition
IGN ON SW
Indicates [ON/OFF] condition of ignition switch in ON position.
ACC ON SW
Indicates [ON/OFF] condition of ignition switch in ACC position.
KEY ON SW
Indicates [ON/OFF] condition of key switch.
KEYLESS LOCK
Indicates [ON/OFF] condition of lock signal from keyfob.
KEYLESS UNLOCK
Indicates [ON/OFF] condition of unlock signal from keyfob.
TRUNK OPNR SW
NOTE:
The item is indicated, but not monitored.
TRNK OPNR MNTR
NOTE:
The item is indicated, but not monitored.
HOOD SW
NOTE:
The item is indicated, but not monitored.
DOOR SW-DR
Indicates [ON/OFF] condition of front door switch (driver side).
DOOR SW-AS
Indicates [ON/OFF] condition of front door switch (passenger side).
DOOR SW-RR
Indicates [ON/OFF] condition of rear door switch RH.
DOOR SW-RL
Indicates [ON/OFF] condition of rear door switch LH.
BACK DOOR SW
Indicates [ON/OFF] condition of back door switch.
KEY CYL LK-SW
Indicates [ON/OFF] condition of door key cylinder switch.
KEY CYL UN-SW
Indicates [ON/OFF] condition of door key cylinder switch.
CDL LOCK SW
Indicates [ON/OFF] condition of door lock and unlock switch.
CDL UNLOCK SW
Indicates [ON/OFF] condition of door lock and unlock switch.
TRANSPONDER
Indicates key ID verification results by [ON/OFF].
INTELLI KEY
NOTE:
The item is indicated, but not monitored.
LOCK STATUS
NOTE:
The item is indicated, but not monitored.
AUTO RELOCK
NOTE:
The item is indicated, but not monitored.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст