Nissan Juke F15. Manual — part 1076
PWO
PRECAUTIONS
PWO-3
< PRECAUTION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
• Turbocharger cooling pump may operate in a few minutes after the ignition switch is turned OFF.
• Example of high-load driving
- Driving for 30 minutes or more at 140 km/h (86 MPH) or more.
- Driving for 30 minutes or more on a steep slope.
• For vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON
the ignition switch.
NOTE:
If the ignition switch is turned ON with any one of the terminals of main battery and sub battery discon-
nected, then DTC may be detected.
• After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.
NOTE:
The removal of 12V battery may cause a DTC detection error.
PWO-4
< WIRING DIAGRAM >
POWER SOCKET
WIRING DIAGRAM
POWER SOCKET
Wiring Diagram
INFOID:0000000012199958
JCMWA6063GB
PWO
POWER SOCKET
PWO-5
< WIRING DIAGRAM >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
JRMWI5110GB
PWO-6
< REMOVAL AND INSTALLATION >
POWER SOCKET
REMOVAL AND INSTALLATION
POWER SOCKET
Exploded View
INFOID:0000000012199959
Removal and Installation
INFOID:0000000012199960
REMOVAL
1. Remove cluster tray. Refer to
IP-13, "Removal and Installation"
2. Pull out inner socket (1) by pushing the pawl (B) of the ring (2)
from the inner socket hole (square) (A).
3. Press the ring pawl from the back of the cluster tray to remove
the ring.
INSTALLATION
Note the following, and install in the reverse order of removal.
JSMIA0455ZZ
1
: Inner socket
2
: Ring
JSMIA0357ZZ
: Pawl
JSMIA0358ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст