Nissan Juke F15. Manual — part 141
YAW RATE/SIDE/DECEL G SENSOR
BRC-155
< REMOVAL AND INSTALLATION >
[WITH VDC]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
YAW RATE/SIDE/DECEL G SENSOR
Exploded View
INFOID:0000000012199761
Removal and Installation
INFOID:0000000012199762
REMOVAL
CAUTION:
Never drop or strike yaw rate/side/decel G sensor, because it has little endurance to impact. Never use
a pneumatic tool.
1. Remove front seat (right side). Refer to
SE-21, "Removal and Installation"
2. Remove floor carpet. Refer to
INT-24, "Removal and Installation"
3. Disconnect yaw rate/side/decel G sensor harness connector.
4. Remove yaw rate/side/decel G sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Never drop or strike yaw rate/transverse/decel G sensor, because it has little endurance to impact. Never
use a power tool.
1.
Yaw rate/side/decel G sensor
2.
Yaw rate/side/decel G sensor har-
ness connector
3.
Bracket
: Vehicle front
: N·m (kg-m, in-lb)
JSFIA0544GB
BRC-156
< REMOVAL AND INSTALLATION >
[WITH VDC]
STEERING ANGLE SENSOR
STEERING ANGLE SENSOR
Removal and Installation
INFOID:0000000012199763
REMOVAL
1. Remove spiral cable assembly. Refer to
SR-15, "Removal and Installation"
2. Remove steering angle sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Perform steering angle sensor neutral position adjustment when steering angle sensor is removed and
installed, or replaced. Refer to
.
VDC OFF SWITCH
BRC-157
< REMOVAL AND INSTALLATION >
[WITH VDC]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
VDC OFF SWITCH
Removal and Installation
INFOID:0000000012199764
REMOVAL
1. Remove lower instrument panel. Refer to
IP-13, "Removal and Installation"
.
2. Remove VDC OFF switch.
INSTALLATION
Installation is the reverse order of removal.
BRC-158
< REMOVAL AND INSTALLATION >
[WITH VDC]
VDC OFF SWITCH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст