Nissan Juke F15. Manual — part 1202
STR-28
< REMOVAL AND INSTALLATION >
STARTER MOTOR
Type: S114-955
NOTE:
Apply high-temperature grease to lubricate the bearing, gears and frictional surface when assembling the
starter.
MR16DDT : Removal and Installation
INFOID:0000000012201590
REMOVAL
1. Disconnect the battery cable from the negative terminal. Refer to
PG-105, "Removal and Installation"
2. Drain engine coolant from radiator. Refer to
(MR except for NISMO RS models).
CAUTION:
Perform this step when engine is cold.
3. Remove charge air cooler. Refer to
EM-32, "Removal and Installation"
(MR for NISMO RS models) or
194, "Removal and Installation"
(MR except for NISMO RS models).
4. Remove CVT water hose on thermostat housing side (MR for NISMO RS CVT models). Refer to
5. Remove radiator hose (lower) on thermostat housing side. Refer to
CO-16, "Removal and Installation"
(MR for NISMO RS models) or
CO-46, "Removal and Installation"
(MR except for NISMO RS models).
6. Move CVT water hose and radiator hose (lower) to a location where they do not inhibit work.
JMBIA4496GB
1.
Magnetic switch assembly
2.
Dust cover kit
3.
Shift lever set
4.
Center bracket (A)
5.
Yoke assembly
6.
Armature assembly
7.
Brush holder assembly
8.
Thrust washer
9.
Rear cover assembly
10. Internal gear
11. Planetary gear
12. Pinion shaft
13. Packing
14. Thrust washer
15. Center bracket (P)
16. E-ring
17. Pinion assembly
18. Pinion stopper
19. Pinion stopper clip
20. Gear case assembly
: N·m (kg-m, in-lb)
: High-temperature grease point
STARTER MOTOR
STR-29
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
7. Open “B” terminal cover, in the direction indicated by an arrow
as shown in the figure.
8. Remove “B” terminal nut and “B” terminal harness.
9. Remove “S” terminal nut and “S” terminal harness.
10. Disconnect harness connector (1) from crankshaft position sen-
sor.
11. Remove harness fixing clip (A) from oil pan (upper), and then
move harness (2) to a location where they do not inhibit work.
12. Remove starter motor mounting bolts.
13. Remove starter motor forward from the vehicle.
INSTALLATION
Note the following items, and install in the reverse order of removal.
CAUTION:
• Be careful to tighten “B” terminal nut to the specified torque.
• After work is complete fill engine coolant. Refer to
(MR for NISMO RS models) or
(MR except for NISMO RS models).
JMBIA3020ZZ
JMBIA3021ZZ
STR-30
< SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Starter Motor
INFOID:0000000012201591
Type
S114 - 955
HITACHI make
Reduction gear type
System voltage
[V]
12
No-load
Terminal voltage
[V]
11
Current
[A]
Less than 110
Revolution
[rpm]
More than 3000
TM-1
TRANSMISSION & DRIVELINE
C
E
F
G
H
I
J
K
L
M
SECTION
TM
A
B
TM
N
O
P
CONTENTS
TRANSAXLE & TRANSMISSION
6MT: RS6F94R
PRECAUTION . . . . . . . . . . . ..
PRECAUTIONS . . . . . . . . . . . . ..
Precaution for Procedure without Cowl Top Cover
Precautions for Removing Battery Terminal . . ...
Service Notice or Precautions for Manual Tran-
saxle . . . . . . . . . . . . . . . . . .
PREPARATION . . . . . . . . . . ...
PREPARATION . . . . . . . . . . . . ..
Special Service Tools . . . . . . . . . . . ..
Commercial Service Tools . . . . . . . . . ..
SYSTEM DESCRIPTION . . . . . . . .
COMPONENT PARTS . . . . . . . . . ...
Component Parts Location . . . . . . . . . ..
STRUCTURE AND OPERATION . . . . . ...
Sectional View . . . . . . . . . . . . . . .
System Description . . . . . . . . . . . . .
DTC/CIRCUIT DIAGNOSIS . . . . . . .
POSITION SWITCH . . . . . . . . . . .
BACK-UP LAMP SWITCH . . . . . . . . . .
BACK-UP LAMP SWITCH : Component Inspec-
tion . . . . . . . . . . . . . . . . . . ..
PARK/NEUTRAL POSITION (PNP) SWITCH . . ...
PARK/NEUTRAL POSITION (PNP) SWITCH :
Component Inspection . . . . . . . . . . .
SYMPTOM DIAGNOSIS . . . . . . . ..
NOISE, VIBRATION AND HARSHNESS
(NVH) TROUBLESHOOTING . . . . . . ...
NVH Troubleshooting Chart . . . . . . . . .
PERIODIC MAINTENANCE . . . . . .
GEAR OIL . . . . . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
Draining . . . . . . . . . . . . . . . . ...
Refilling . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . ...
SIDE OIL SEAL . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
POSITION SWITCH . . . . . . . . . . ..
Removal and Installation . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
CONTROL LINKAGE . . . . . . . . . .
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
AIR BREATHER HOSE . . . . . . . . .
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
UNIT REMOVAL AND INSTALLATION . ..
TRANSAXLE ASSEMBLY . . . . . . . .
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
UNIT DISASSEMBLY AND ASSEMBLY .
TRANSAXLE ASSEMBLY . . . . . . . .
Exploded View . . . . . . . . . . . . . . .
Disassembly . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст