Nissan Juke F15. Manual — part 744
EXL-196
< SYMPTOM DIAGNOSIS >
[HALOGEN TYPE]
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Turn signal lamp does not
blink
Indicator lamp is normal
(Applicable side per-
forms high flasher activa-
tion)
• Front turn signal lamp
- Front turn signal lamp power sup-
ply/ground circuit
- Front turn signal lamp bulb
- Front turn signal lamp bulb socket
- BCM
• Side turn signal lamp
- Side turn signal lamp power sup-
ply/ground circuit
- Side turn signal lamp
- BCM
• Rear turn signal lamp
- Rear turn signal lamp power sup-
ply/ground circuit
- Rear turn signal lamp bulb
- Rear turn signal lamp bulb socket/
harness
- BCM
Turn signal lamp circuit
Refer to
Indicator lamp is included
• Combination switch input/output
signal circuit
• Combination switch
• BCM
Combination switch
Refer to
.
Turn signal indicator lamp
does not blink
(Turn signal lamp is normal)
One side
Combination meter
—
Both sides
(Always)
• Turn indicator signal
• BCM
• Combination meter
• Combination meter
Data monitor “TURN IND”
• BCM (FLASHER)
Active test “FLASHER”
Both sides
(Only when activating
hazard warning lamp
with ignition switch OFF)
• Combination meter power supply/
ground circuit
• Combination meter
Combination meter
Power supply and ground circuit
Refer to
• Hazard warning lamp does not activate
(Turn signal is normal)
• Hazard warning lamp continues activating
• Hazard switch signal/ground cir-
cuit
• Hazard switch
• BCM
Hazard switch
Refer to
Symptom
Possible cause
Inspection item
NORMAL OPERATING CONDITION
EXL-197
< SYMPTOM DIAGNOSIS >
[HALOGEN TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
NORMAL OPERATING CONDITION
Description
INFOID:0000000012201768
AUTO LIGHT SYSTEM
The headlamp may not be turned ON/OFF immediately after passing dark area or bright area (short tunnel,
sky bridge, shadowed area, etc.) while using the auto light system. This is caused by for the control difference.
This is normal.
EXL-198
< SYMPTOM DIAGNOSIS >
[HALOGEN TYPE]
BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON
BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON
Description
INFOID:0000000012201769
Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.
Diagnosis Procedure
INFOID:0000000012201770
1.
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HIGH BEAM REQUEST SIGNAL
With CONSULT
1. Turn ignition switch ON.
2. Select “HL HI REQ” in “Data Monitor” mode of “IPDM E/R” using CONSULT.
3. With operating the lighting switch, check the monitor status.
Is the inspection result normal?
YES
>> Replace IPDM E/R. Refer to
PCS-37, "Removal and Installation"
NO
>> Replace BCM. Refer to
BCS-94, "Removal and Installation"
Monitor item
Condition
Monitor status
HL HI REQ
Lighting switch
(2ND)
HI or PASS
On
LO
Off
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
EXL-199
< SYMPTOM DIAGNOSIS >
[HALOGEN TYPE]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
Description
INFOID:0000000012201771
Both side headlamps (LO) are not turned ON in any condition.
Diagnosis Procedure
INFOID:0000000012201772
1.
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK LOW BEAM REQUEST SIGNAL
With CONSULT
1. Turn ignition switch ON.
2. Select “HL LO REQ” in “Data Monitor” mode of “IPDM E/R” using CONSULT.
3. With operating the lighting switch, check the monitor status.
Is the inspection result normal?
YES
>> Replace IPDM E/R. Refer to
PCS-37, "Removal and Installation"
.
NO
>> Replace BCM. Refer to
BCS-94, "Removal and Installation"
Monitor item
Condition
Monitor status
HL LO REQ
Lighting switch
2ND
On
OFF
Off
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст