Nissan Juke F15. Manual — part 66
BCS
DIAGNOSIS SYSTEM (BCM)
BCS-19
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
INT LAMP
INT LAMP : CONSULT Function (BCM - INT LAMP)
INFOID:0000000012965031
WORK SUPPORT
*: Factory setting
DATA MONITOR
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.
JPLIA0093GB
Service item
Setting item
Setting
ROOM LAMP TIMER SET
MODE 2
7.5 sec.
Sets the interior room lamp ON time. (Timer operating time)
MODE 3*
15 sec.
MODE 4
30 sec.
SET I/L D-UNLCK INTCON
On*
With the interior room lamp timer function
Off
Without the interior room lamp timer function
ROOM LAMP ON TIME SET
MODE 1
0.5 sec.
Sets the interior room lamp gradual brightening time.
MODE 2*
1 sec.
MODE 3
2 sec.
MODE 4
3 sec.
MODE 5
0 sec.
ROOM LAMP OFF TIME SET
MODE 1
0.5 sec.
Sets the interior room lamp gradual dimming time.
MODE 2*
1 sec.
MODE 3
2 sec.
MODE 4
3 sec.
MODE 5
0 sec.
R LAMP TIMER LOGIC SET
MODE 1*
Interior room lamp timer activates with synchronizing all doors.
MODE 2
Interior room lamp timer activates with synchronizing the driver door
only.
FOG LAMP OVERRIDE
On
With front fog override function
Off*
Without front fog override function
BCS-20
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
DIAGNOSIS SYSTEM (BCM)
ACTIVE TEST
HEADLAMP
HEADLAMP : CONSULT Function (BCM - HEAD LAMP) (XENON TYPE)
INFOID:0000000012965020
WORK SUPPORT
Monitor item
[Unit]
Description
REQ SW-DR
[On/Off]
Indicated [On/Off] condition of door request switch (driver side)
REQ SW-AS
[On/Off]
Indicated [On/Off] condition of door request switch (passenger side)
REQ SW-RR
[On/Off]
NOTE:
This item is displayed, but cannot be monitored
REQ SW-RL
[On/Off]
NOTE:
This item is displayed, but cannot be monitored
PUSH SW
[On/Off]
Indicates [On/Off] condition of push-button ignition switch
UNLK SEN -DR
[On/Off]
Indicates [On/Off] condition of driver door UNLOCK status
DOOR SW-DR
[On/Off]
Indicated [On/Off] condition of front door switch (driver side)
DOOR SW-AS
[On/Off]
Indicated [On/Off] condition of front door switch (passenger side)
DOOR SW-RR
[On/Off]
Indicated [On/Off] condition of rear door switch RH
DOOR SW- RL
[On/Off]
Indicated [On/Off] condition of rear door switch LH
DOOR SW- BK
[On/Off]
Indicated [On/Off] condition of back door switch
CDL LOCK SW
[On/Off]
Indicated [On/Off] condition of lock signal from door lock unlock switch
CDL UNLOCK SW
[On/Off]
Indicated [On/Off] condition of unlock signal from door lock unlock switch
TRNK/HAT MNTR
[On/Off]
NOTE:
This item is displayed, but cannot be monitored
KEY CYL LK-SW
[On/Off]
Indicated [On/Off] condition of lock signal from door key cylinder
KEY CYL UN-SW
[On/Off]
Indicated [On/Off] condition of unlock signal from door key cylinder
RKE-LOCK
[On/Off]
Indicates [On/Off] condition of LOCK signal from Intelligent Key
RKE-UNLOCK
[On/Off]
Indicates [On/Off] condition of UNLOCK signal from Intelligent Key
Test item
Operation
Description
INT LAMP
On
Outputs the interior room lamp control signal.
Off
Stops the interior room lamp control signal.
STEP LAMP TEST
On
NOTE:
This item is indicated, but can not tested
Off
BCS
DIAGNOSIS SYSTEM (BCM)
BCS-21
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
*
1
: For models without auto light system, this item cannot be used.
*
2
: Factory setting
DATA MONITOR
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable
to this vehicle, refer to CONSULT display items.
Service item
Setting item
Setting
CUSTOM A/LIGHT SETTING*
1
MODE1*
2
Normal
MODE2
More sensitive setting than normal setting (Turns ON earlier than normal operation)
MODE3
More sensitive setting than MODE2 (Turns ON earlier than MODE2)
MODE4
Less sensitive setting than normal setting (Turns ON later than normal operation)
BATTERY SAVER SET
On*
2
With the exterior lamp battery saver function
Off
Without the exterior lamp battery saver function
ILL DELAY SET*
1
MODE1*
2
45 sec.
Sets delay timer function timer operation time.
(All doors closed)
MODE2
Without the function
MODE3
30 sec.
MODE4
60 sec.
MODE5
90 sec.
MODE6
120 sec.
MODE7
150 sec.
MODE8
180 sec.
HEAD LIGHT TIMER
MODE1
10 sec.
Sets follow me home function activating time
MODE2*
2
30 sec.
AUTO LIGHT LOGIC SET*
1
MODE1*
2
With twilight ON custom & with wiper INT, LO and HI
MODE2
With twilight ON custom & with wiper LO and HI
MODE3
With twilight ON custom & without
MODE4
Without twilight ON custom & with wiper INT, LO and HI
MODE5
Without twilight ON custom & with wiper LO and HI
MODE6
Without twilight ON custom & without
Monitor item
[Unit]
Description
PUSH SW
[On/Off]
Indicates [On/Off] condition of push-button ignition switch
ENGINE STATE
[STOP/STALL/CRANK/RUN]
Indicates [STOP/STALL/CRANK/RUN] condition of engine states
VEH SPEED 1
[km/h]
Display the vehicle speed signal received from combination meter by numerical value [km/h]
BCS-22
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
DIAGNOSIS SYSTEM (BCM)
*
1
: For models without auto light system, this item cannot be monitored.
*
2
: For models without front fog lamp, this item cannot be monitored.
ACTIVE TEST
TURN SIGNAL R
[On/Off]
Each switch status that BCM judges from the combination switch reading function
TURN SIGNAL L
[On/Off]
TAIL LAMP SW
[On/Off]
HI BEAM SW
[On/Off]
HEAD LAMP SW 1
[On/Off]
HEAD LAMP SW 2
[On/Off]
PASSING SW
[On/Off]
AUTO LIGHT SW*
1
[On/Off]
FR FOG SW*
2
[On/Off]
DOOR SW-DR
[On/Off]
Indicated [On/Off] condition of front door switch (driver side)
DOOR SW-AS
[On/Off]
Indicated [On/Off] condition of front door switch (passenger side)
DOOR SW-RR
[On/Off]
Indicated [On/Off] condition of rear door switch RH
DOOR SW-RL
[On/Off]
Indicated [On/Off] condition of rear door switch LH
DOOR SW-BK
[On/Off]
Indicated [On/Off] condition of back door switch
OPTI SEN (DTCT)
[V]
The value of outside brightness voltage input from the optical sensor
OPTI SEN (FILT)
[V]
The value of outside brightness voltage filtered by BCM
OPTICAL SENSOR
[On/Off/NG]
NOTE:
This item cannot be monitored
Monitor item
[Unit]
Description
Test item
Operation
Description
TAIL LAMP
On
• Transmits the position light request signal to IPDM E/R via CAN communication to
turn the parking, license plate and tail lamps ON
• Transmits the position light request signal to combination meter via CAN commu-
nication to turn the position lamp indicator lamp ON
Off
Stops the position light request signal transmission
HEAD LAMP
HI
• Transmits the high beam request signal to IPDM E/R via CAN communication to
turn the headlamp (HI) ON
• Transmits the high beam request signal to combination meter via CAN communi-
cation to turn the high beam indicator lamp ON
Low
Transmits the low beam request signal to IPDM E/R via CAN communication to turn
the headlamp (LO) ON
Off
Stops the high beam request signal and low beam request signal transmission
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст