Nissan Juke F15. Manual — part 609
NORMAL OPERATING CONDITION
EC-1249
< SYMPTOM DIAGNOSIS >
[MR EXCEPT FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
NORMAL OPERATING CONDITION
Description
INFOID:0000000012198775
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and
engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off var-
ies based on engine speed.
Fuel cut will be operated until the engine speed reaches 1,500 rpm, then fuel cut will be cancelled.
NOTE:
This function is different from deceleration control listed under direct injection gasoline system,
EC-1250
< PERIODIC MAINTENANCE >
[MR EXCEPT FOR NISMO RS MODELS]
IDLE SPEED
PERIODIC MAINTENANCE
IDLE SPEED
Inspection
INFOID:0000000012198776
1.
CHECK IDLE SPEED
With CONSULT
Check idle speed in “DATA MONITOR” mode with CONSULT.
>> INSPECTION END
IGNITION TIMING
EC-1251
< PERIODIC MAINTENANCE >
[MR EXCEPT FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
IGNITION TIMING
Inspection
INFOID:0000000012198777
1.
CHECK IGNITION TIMING
1. Attach timing light to the ignition coil No.1 harness.
2. Check ignition timing.
>> INSPECTION END
1
: Timing indicator
PBIB3263E
EC-1252
< PERIODIC MAINTENANCE >
[MR EXCEPT FOR NISMO RS MODELS]
EVAPORATIVE EMISSION SYSTEM
EVAPORATIVE EMISSION SYSTEM
Inspection
INFOID:0000000012198778
1.
CHECK EVAP CANISTER
1. Block port (B).
2. Blow air into port (A) and check that it flows freely out of port (C).
3. Release blocked port (B).
4. Apply vacuum pressure to port (B) and check that vacuum pres-
sure exists at the ports (A) and (C).
5. Block port (A) and (B).
6. Apply pressure to port (C) and check that there is no leakage.
>> INSPECTION END
PBIB1212E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст