Nissan Juke F15. Manual — part 46
AV-170
< DTC/CIRCUIT DIAGNOSIS >
[AUDIO WITH NAVIGATION]
STEERING SWITCH GROUND CIRCUIT
STEERING SWITCH GROUND CIRCUIT
Description
INFOID:0000000012202585
Transmits the steering switch signal to NAVI control unit.
Diagnosis Procedure
INFOID:0000000012202586
1.
CHECK STEERING SWITCH SIGNAL GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect NAVI control unit connector and spiral cable connector.
3. Check continuity between NAVI control unit harness connector and spiral cable harness connector.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair harness or connector.
2.
CHECK SPIRAL CABLE
Check spiral cable.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Replace spiral cable. Refer to
3.
CHECK GROUND CIRCUIT
1. Connect NAVI control unit connector.
2. Check continuity between NAVI control unit harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Replace NAVI control unit. Refer to
AV-182, "Removal and Installation"
4.
CHECK STEERING SWITCH
1. Turn ignition switch OFF.
2. Check steering switch. Refer to
AV-170, "Component Inspection"
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Replace steering switch. Refer to
AV-195, "Removal and Installation"
Component Inspection
INFOID:0000000012202587
Measure the resistance between the steering switch connector.
NAVI control unit
Spiral cable
Continuity
Connector
Terminal
Connector
Terminal
M108
15
M33
33
Existed
NAVI control unit
Ground
Continuity
Connector
Terminal
M108
15
Existed
AV
STEERING SWITCH GROUND CIRCUIT
AV-171
< DTC/CIRCUIT DIAGNOSIS >
[AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
Steering switch
Condition
Resistance
(Approx.)
Ω
Terminal
Terminal
14
17
TEL switch ON
709 – 737
SEEK DOWN switch
ON
315 – 327
SEEK UP switch ON
119 – 123
SOURCE switch ON
0
15
TEL END switch ON
315 – 327
VOL UP switch ON
119 – 123
VOL DOWN switch ON
0
JSNIA8044GB
AV-172
< SYMPTOM DIAGNOSIS >
[AUDIO WITH NAVIGATION]
NAVIGATION SYSTEM
SYMPTOM DIAGNOSIS
NAVIGATION SYSTEM
Symptom Table
INFOID:0000000012202588
RELATED TO NAVIGATION
NOTE:
Combined part of AV switch and NAVI control unit.
Symptoms
Check items
Probable malfunction location / Action
to take
Display does not turn ON.
All switches cannot be operated.
• NAVI control unit power supply and
ground circuit.
Refer to
• Disconnect the battery negative ter-
minal. Reconnect the terminal. If the
same symptom occurs, replace NAVI
control unit. Refer to
.
All switches can be operated.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace NAVI control
unit. Refer to
All switches cannot be operat-
ed.
Display does not turn ON.
• NAVI control unit power supply and
ground circuit.
Refer to
• Disconnect the battery negative ter-
minal. Reconnect the terminal. If the
same symptom occurs, replace NAVI
control unit. Refer to
.
Display turn ON.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace NAVI control
unit. Refer to
Only specified switch cannot be
operated.
–
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace NAVI control
unit. Refer to
Map screen is not displayed.
(RGB image other than map is
normal.)
• Check that the map
SD card is in the SD
card slot.
• Check “SD Card Ac-
cess” in “SERVICE
SYSTEM SELF
TEST”, “SERVICE
MENU”.
“OK” is displayed for “SD
Card Access”.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace Map SD card.
“OK” is not displayed for “SD
Card Access”.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace NAVI control
unit or Map SD card.
AV
NAVIGATION SYSTEM
AV-173
< SYMPTOM DIAGNOSIS >
[AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
*: check that voice guidance is set to on in the set up menu of navigation.
*: check that the volume of voice guidance is not set to low.
RELATED TO AUDIO
RELATED TO USB
NOTE:
Voice guidance is not heard
*
Check that the map
SD card is in the SD
card slot.
“OK” is displayed for SD
Card Access.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace Map SD card.
Check “SD Card Ac-
cess” in “SERVICE
SYSTEM SELF
TEST”, “SERVICE
MENU”.
“OK” is not displayed for SD
Card Access.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace NAVI control
unit. Refer to
Display does not dim.
Check “Illumination
Signal” in “SERVICE
SYSTEM STATUS”,
“SERVICE MENU”.
“Illumination Signal” reaches
100% when the lighting
switch is ON.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace NAVI control
unit. Refer to
“Illumination Signal” does
not reach 100% when the
lighting switch is ON.
Illumination signal circuit
Vehicle icon does not move.
Check “Speed Signal”
in “SERVICE SYS-
TEM STATUS”, “SER-
VICE MENU”.
A value of “Speed Signal”
changes according to vehi-
cle speeds.
Disconnect the battery negative termi-
nal. Reconnect the terminal. If the same
symptom occurs, replace NAVI control
unit or GPS antenna.
A value of “Speed Signal”
does not change according
to vehicle speeds.
Vehicle speed signal circuit
Symptoms
Check items
Probable malfunction location / Action
to take
Symptoms
Check items
Probable malfunction location
No sound comes out or the lev-
el of the sound is low.
No sound from all speakers.
NAVI control unit power supply and ground circuits mal-
function. Refer to
AV-161, "NAVI CONTROL UNIT : Diag-
Only a certain speaker (front right, front
left, rear right, or rear left) does not out-
put sound.
• Poor connector connection of speaker.
• Sound signal circuit malfunction between NAVI control
unit and speaker.
• Malfunction in speaker.
• Malfunction in NAVI control unit.
Noise is mixed with audio.
Noise comes out from all speaker.
Malfunction in NAVI control unit.
Noise comes out only from a certain
speaker (front right, front left, rear right,
or rear left).
• Poor connector connection of speaker.
• Sound signal circuit malfunction between NAVI control
unit and speaker.
• Malfunction in speaker.
• Poor installation of speaker (e.g. backlash and loose-
ness)
• Malfunction in NAVI control unit.
Noise is mixed with radio only (when the
car hits a bump or while driving over bad
roads).
Poor connector connection of antenna or antenna feeder.
Radio is not received or poor
reception.
• Other audio sounds are normal.
• Any radio cannot be received or poor
reception is caused even after moving
to a service area with good reception
(e.g. a place with clear view and no ob-
stacles generating external noises).
• Antenna amp. ON signal circuit malfunction.
• Poor connector connection of antenna or antenna feed-
er.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст