Nissan Primera P12. Manual — part 717
WW-52
COMBINATION SWITCH
COMBINATION SWITCH
PFP:25567
Switch Circuit Inspection
EKS009PV
MKWA1017E
HEADLAMP WASHER
WW-53
C
D
E
F
G
H
I
J
L
M
A
B
WW
HEADLAMP WASHER
PFP:28620
System Description
EKS009PW
The headlamp washer is controlled by the smart entrance control unit and ground supplied, the headlamp
washer motor operates.
Power is supplied at all times.
●
through 30A fusible link (letter E , located in fuse and fusible link box)
●
to headlamp washer motor terminal 2, and
●
through 10A fuse (No. 32, located in fuse and fusible link box)
●
to lighting switch terminal 11
●
through 10A fuse [No. 10, located in fuse block (J/B)]
●
to smart entrance control unit terminal 29.
Ground is supplied to smart entrance control unit terminal 53 through body grounds M16, M50, M70 and F115.
When headlamp washer switch is pushed during lighting switch is in 1ST or 2ND position, ground is supplied
●
to smart entrance control unit terminal 24
●
through headlamp washer switch and body grounds E10 and E58, and
●
to headlamp washer motor terminal 1
●
through smart entrance control unit terminal 62.
With ignition switch in the ON or START position and lighting switch is in 1ST or 2ND position, power is sup-
plied, the headlamp washer motor operates.
WW-54
HEADLAMP WASHER
Wiring Diagram —HLC—
EKS009PX
MKWA1015E
HEADLAMP WASHER
WW-55
C
D
E
F
G
H
I
J
L
M
A
B
WW
Removal and Installation for Washer Nozzle
EKS009PY
REMOVAL
1.
Remove front bumper. Refer to EI section in P12 ESM
(SM2E00-1P12E0E)
2.
Remove hose clip and washer nozzle metal clip.
3.
Remove washer nozzle from front bumper.
INSTALLATION
Installation is in the reverse order of removal.
Inspection for Washer Nozzle
EKS009PZ
CHECK VALVE
●
Blow air in the injection direction, and check that air flows only
one way. Make sure that the reverse direction is not possible.
Removal and Installation for Washer Tank
EKS009Q0
Refer to
WW-16, "Removal and Installation for Washer Tank"
,
Removal and Installation for Washer Pump
EKS009Q1
1.
Remove front bumper. Refer to EI section in P12 ESM
(SM2E00-1P12E0E)
2.
Remove washer pump connector and hose.
3.
Pull out washer pump in the direction of the arrow in the figure,
and remove the washer pump from the washer tank.
CAUTION:
When installing washer pump, there should be no packing twist,
etc.
PKIA0490E
PKIA0491E
PKIA0494E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст