Nissan Primera P12. Manual — part 103
HATCHBACK
BL-121
C
D
E
F
G
H
J
K
L
M
A
B
BL
Removal and Installation of Weather-strip
EIS005IO
1.
Working from the upper section, align weather-strip mark with vehicle center position mark and install
weather-strip onto the back door.
2.
For the lower section, align the weather-strip seam with center of the striker.
3.
After installation, pull the weather-strip gently to ensure that there is no loose section.
NOTE:
Make sure the weather-strip is fit tightly at each corner and back door rear plate.
SIIA1932E
BL-122
FUEL FILLER LID OPENER
FUEL FILLER LID OPENER
PFP:78820
Component Parts Location
EIS005IP
SIIA0717E
THEFT WARNING SYSTEM
BL-123
C
D
E
F
G
H
J
K
L
M
A
B
BL
THEFT WARNING SYSTEM
PFP:25362
Component Parts and Harness Connector Location
EIS005IQ
SIIA1646E
BL-124
THEFT WARNING SYSTEM
System Description
EIS005IR
DESCRIPTION
Operation Flow
Setting The Theft Warning System
Initial condition
1.
Ignition switch is in OFF position.
2.
Close all doors.
3.
Close hood and trunk lid (Sedan) or back door (Wagon).
Disarmed phase
●
When the vehicle security system is in the disarmed phase, the security indicator lamp blinks every 2.6
seconds.
Pre-armed phase and armed phase
When the following operation 1 or 2 is performed, the vehicle security system turns into the “pre-armed”
phase. (The security indicator lamp illuminates.)
1.
Smart entrance control unit receives LOCK signal from controller after hood, all doors and trunk (Sedan)
are closed.
2.
Hood, all doors and trunk (Sedan) are closed after front doors are locked by key, lock/unlock switch or
remote controller.
After about 30 seconds, the system automatically shifts into the “armed” phase (the system is set). (The secu-
rity indicator lamp blinks every 2.6 seconds.)
Canceling The Set Theft Warning System
When the following 1 or 2 operation is performed, the armed phase is canceled.
1.
Unlock the doors with remote controller.
2.
Insert key in ignition key cylinder and turn it to ON.
Activating The Alarm Operation of The Theft Warning System
Make sure the system is in the armed phase. (The security indicator lamp blinks every 2.6 seconds.)
When the following operation 1, 2, 3, 4 or 5 is performed, the system sounds the horns and flashes about 30
seconds.
1.
Engine hood, trunk lid (Sedan), back door (Wagon) or any doors is opened before unlocking door with the
remote controller.
2.
A door is unlocked without using the remote controller.
3.
The ignition is switched ON without using a NATS registered key.
4.
The ultra sonic sensing is triggered.
5.
Disconnecting and connecting the battery connector before canceling armed phase.
SEL334W
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст