Nissan Primera P12. Manual — part 308
DTC U1000 CAN COMMUNICATION LINE
EC-417
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
Wiring Diagram
EBS0153U
MBWA0370E
EC-418
[YD (WITHOUT EURO-OBD)]
DTC U1000 CAN COMMUNICATION LINE
Diagnostic Procedure
EBS0153V
1.
INSPECTION START
1.
Turn ignition switch ON.
2.
Select “CAN DIAG SUPPORT MNTR” in “DATA MONITOR” mode with CONSULT-II.
3.
Print out the CONSULT-II screen.
Models with ESP
Models without ESP
>> Go to
.
MBIB0868E
MBIB0009E
DTC P0016 CKP - CMP CORRELATION
EC-419
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P0016 CKP - CMP CORRELATION
PFP:10328
On Board Diagnosis Logic
EBS0153W
The MI will not light up for this self-diagnosis.
DTC Confirmation Procedure
EBS0153X
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1.
Turn ignition switch ON.
2.
Select “DATA MONITOR” mode with CONSULT-II.
3.
Start engine and let it idle for at least 5 seconds.
4.
If DTC is detected, go to
EC-419, "Diagnostic Procedure"
.
Diagnostic Procedure
EBS0153Y
1.
CHECK CAMSHAFT POSITION SENSOR
Refer to
EC-510, "Component Inspection"
.
OK or NG
OK
>> GO TO 2.
NG
>> Replace camshaft position sensor.
2.
CHECK SPROCKET
Visually check for chipping signal plate gear tooth.
OK or NG
OK
>> GO TO 3.
NG
>> Remove debris and clean the signal plate or replace sprocket.
3.
CHECK CRANKSHAFT POSITION SENSOR
Refer to
EC-499, "Component Inspection"
.
OK or NG
OK
>> GO TO 4.
NG
>> Replace crankshaft position sensor.
DTC No.
Trouble diagnosis
name
DTC detecting condition
Possible cause
P0016
Crankshaft position -
camshaft position cor-
relation
The correlation between crankshaft position sen-
sor signal and camshaft position sensor signal is
out of the normal range.
●
Camshaft position sensor
●
Crankshaft position sensor
●
Timing chain
●
Signal plate
SEF817Y
EC-420
[YD (WITHOUT EURO-OBD)]
DTC P0016 CKP - CMP CORRELATION
4.
CHECK GEAR TOOTH
Visually check for chipping signal plate gear tooth.
OK or NG
OK
>> GO TO 5.
NG
>> Replace the signal plate.
5.
CHECK TIMING CHAIN
Refer to
EM-63, "SECONDARY TIMING CHAIN"
,
and
.
OK or NG
OK
>> GO TO 6.
NG
>> Replace timing chain.
6.
CHECK INTERMITTENT INCIDENT
Refer to
EC-408, "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT"
.
>> INSPECTION END
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст