Nissan Juke (2016 year). Service Repair Manual — part 8
AV-52
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
REAR DOOR SPEAKER
REAR DOOR SPEAKER
Removal and Installation
INFOID:0000000012202478
REMOVAL
1. Remove rear door finisher. Refer to
INT-16, "Removal and Installation"
.
2. Remove rear door speaker screws, then disconnect rear door speaker connector and remove rear door
speaker.
INSTALLATION
Install in the reverse order of removal.
Revision: November 2015
2016 JUKE
AV
TWEETER
AV-53
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
TWEETER
Removal and Installation
INFOID:0000000012202479
REMOVAL
1. Remove front pillar garnish. Refer to
INT-18, "FRONT PILLAR GARNISH : Removal and Installation"
2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter.
INSTALLATION
Install in the reverse order of removal.
Revision: November 2015
2016 JUKE
AV-54
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
MICROPHONE
MICROPHONE
Removal and Installation
INFOID:0000000012202480
REMOVAL
1. Remove headlining. Refer to
INT-27, "NORMAL ROOF : Removal and Installation"
30, "SUNROOF : Removal and Installation"
2. Remove microphone connector and pawl to remove microphone.
INSTALLATION
Install in the reverse order of removal.
Revision: November 2015
2016 JUKE
AV
STEERING SWITCH
AV-55
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
STEERING SWITCH
Exploded View
INFOID:0000000012202481
.
Removal and Installation
INFOID:0000000012202482
REMOVAL
ST-9, "Removal and Installation"
.
INSTALLATION
Install in the reverse order of removal.
Revision: November 2015
2016 JUKE
AV-56
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
REAR VIEW CAMERA
REAR VIEW CAMERA
Removal and Installation
INFOID:0000000012202483
REMOVAL
1. Remove back door lower finisher. Refer to
INT-39, "BACK DOOR LOWER FINISHER : Removal and
.
2. Remove connector to remove rear view camera.
INSTALLATION
Install in the reverse order of removal.
Adjustment
INFOID:0000000012202484
Adjust the guide line position if the guide line position is shifted after installing the rear view camera.
1. Draw lines on rearward area of the vehicle passing through the
following points: 200 mm (7.87 in) from both sides of the vehicle,
and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the
bumper.
2. Set into “Camera system” mode of Confirmation / Adjustment
mode.
3. Press “1” or “2” switches, and then select the guiding line pattern
so that its angle is aligned with the correction line of the rear of
the vehicle.
4. Make fine adjustment to the correction line of the rear of the
vehicle with “3”, “4”, “5” or “6” switches so that its position is
aligned with the guiding line. Press “ENTER/SETTING” switch
and record the adjusted guiding line position to the camera con-
trol unit.
CAUTION:
Never operate other function such as pressing BACK while writing index data.
SKIB3691E
Selected pattern
: 7
Up/Down adjustment range
: (
−
20) – (20)
Left/Right adjustment range
: (
−
20) – (20)
JSNIA1876ZZ
Revision: November 2015
2016 JUKE
AV
USB CONNECTOR AND AUX JACK
AV-57
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
USB CONNECTOR AND AUX JACK
Removal and Installation
INFOID:0000000012202485
REMOVAL
1. Remove cluster tray. Refer to
IP-13, "Removal and Installation"
.
2. Push the pawl from the back of cluster tray to remove USB connector and AUX jack.
INSTALLATION
Install in the reverse order of removal.
Revision: November 2015
2016 JUKE
AV-58
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
ANTENNA BASE
ANTENNA BASE
Exploded View
INFOID:0000000012202486
Removal and Installation
INFOID:0000000012202487
REMOVAL
1. Remove headlining. Refer to
INT-27, "NORMAL ROOF : Removal and Installation"
30, "SUNROOF : Removal and Installation"
2. Disconnect antenna feeder connector.
3. Remove nut to remove antenna base.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
If the antenna base mounting nut is tightened looser than the specified torque, then this will lower the
sensitivity of the antenna. On the other hand, if the nut is tightened tighter than the specified torque,
then this will deform the roof panel.
JSNIA3161GB
1.
Antenna rod
2.
Antenna base
:
N·m (kg-m, in-fb)
Revision: November 2015
2016 JUKE
AV
ANTENNA FEEDER
AV-59
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ANTENNA FEEDER
Feeder Layout
INFOID:0000000012202488
: Indicates that the part is connected at points with same symbol in actual vehicle.
JSNIA8048GB
Revision: November 2015
2016 JUKE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст