Nissan Pathfinder (2006 year). Manual — part 252
SERVICE DATA AND SPECIFICATIONS (SDS)
FAX-13
C
E
F
G
H
I
J
K
L
M
A
B
FAX
2006 Pathfinder
SERVICE DATA AND SPECIFICATIONS (SDS)
PFP:00030
Wheel Bearing
EDS003AF
Drive Shaft
EDS003AG
Boot Bands
EDS003LI
Unit: mm (in)
Axial end play limit
0.05 mm (0.002 in) or less
Drive shaft joint type
Final drive side
Rzeppa
Wheel side
Rzeppa
Grease
Quality
Genuine NISSAN Grease or equivalent
Capacity
Final drive side
120 - 140 g (4.23 - 4.94 oz)
Wheel side
115 - 135 g (4.01 - 4.76 oz)
Boot installed length "L"
Final drive side
163.9 - 164.3 mm (6.45 - 6.47 in)
Wheel side
135.1 mm (5.32 in)
SDIA2493E
Dimension "M"
1.0 - 4.0 (0.39 - 1.57)
DSF0047D
FAX-14
SERVICE DATA AND SPECIFICATIONS (SDS)
2006 Pathfinder
FL-1
FUEL SYSTEM
B ENGINE
CONTENTS
C
D
E
F
G
H
I
J
K
L
M
SECTION
A
FL
2006 Pathfinder
PRECAUTIONS . . . . . . . . . . . . . . .. 2
PREPARATION . . . . . . . . . . . . . . ... 4
Special Service Tools . . . . . . . . . . . ... 4
Commercial Service Tool . . . . . . . . . . . 4
FUEL SYSTEM . . . . . . . . . . . . . . ... 5
Checking Fuel Lines . . . . . . . . . . . . . 5
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND
FUEL PUMP ASSEMBLY . . . . . . . . . . ... 6
Removal and Installation . . . . . . . . . . .. 6
FUEL TANK . . . . . . . . . . . . . . . .. 11
Removal and Installation . . . . . . . . . . 11
FL-2
PRECAUTIONS
2006 Pathfinder
PRECAUTIONS
PFP:00001
Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER”
EBS00T2G
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:
●
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
●
Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
●
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
General Precautions
EBS00QUD
WARNING:
When replacing fuel line parts, be sure to observe the following.
●
Put a “CAUTION: FLAMMABLE” sign in the workshop.
●
Be sure to work in a well ventilated area and furnish the workshop with a CO
2
fire extinguisher.
●
Do not smoke while servicing the fuel system. Keep open flames and sparks away from the work
area.
CAUTION:
●
Use gasoline required by the regulations for the octane rating number. Refer to
for Fuel (Unleaded Premium Gasoline Recommended)"
●
Before removing fuel line parts, carry out the following procedures:
–
Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in
safe area.
–
Release fuel pressure from the fuel lines. Refer to
EC-79, "FUEL PRESSURE RELEASE"
–
Disconnect the battery negative terminal.
●
Always replace O-rings and clamps with new ones.
●
Do not kink or twist hoses when they are being installed.
●
Do not tighten hose clamps excessively to avoid damaging hoses.
●
Tighten high-pressure rubber hose clamp so that clamp end is 3 mm (0.12 in) from hose end.
●
Ensure that clamp screw does not contact adjacent parts.
PRECAUTIONS
FL-3
C
D
E
F
G
H
I
J
K
L
M
A
FL
2006 Pathfinder
●
After connecting the fuel tube quick connectors, make sure
the quick connectors are secure.
Ensure that the connector and resin tube do not contact
any adjacent parts.
●
After installing tubes, make sure there is no fuel leakage at
connections in the following steps.
–
Apply fuel pressure to fuel lines with turning ignition switch
ON (with engine stopped). Then check for fuel leaks at con-
nections.
–
Start the engine and rev it up and check for fuel leaks at
connections.
●
Use only a Genuine NISSAN fuel filler cap as a replacement.
If an incorrect fuel filler cap is used, the MIL may come on.
●
For servicing “Evaporative Emission System” parts, refer to
EC-32, "EVAPORATIVE EMISSION SYSTEM"
.
●
For servicing “On Board Refueling Vapor Recovery
(ORVR)” parts, refer to
PBIC1268E
FL-4
PREPARATION
2006 Pathfinder
PREPARATION
PFP:00002
Special Service Tools
EBS00QUA
The actual shapes of the Kent-Moore tools may differ from those of the special tools illustrated here.
Commercial Service Tool
EBS00QUB
Tool number
(Kent-Moore No.)
Tool name
Description
—
(J-45722)
130 mm lock ring tool
Removing and installing fuel tank lock ring
LBIA0398E
Tool name
Description
Power tool
Loosening bolts and nuts
PBIC0190E
FUEL SYSTEM
FL-5
C
D
E
F
G
H
I
J
K
L
M
A
FL
2006 Pathfinder
FUEL SYSTEM
PFP:17503
Checking Fuel Lines
EBS00QUC
Inspect fuel lines, fuel filler cap and fuel tank for improper attach-
ment, leaks, cracks, damage, loose connections, chafing or deterio-
ration.
If necessary, repair or replace damaged parts.
SMA803A
FL-6
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY
2006 Pathfinder
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY
PFP:17042
Removal and Installation
EBS00QUE
1.
Lock ring
2.
Fuel level sensor, fuel filter, and fuel
pump assembly
3.
Fuel level sensor, fuel filter, and fuel
pump assembly O-ring
4.
EVAP hose
5.
Fuel tank
6.
Fuel tank straps
7.
Fuel tank shield
8.
Lower fuel filler hose
9.
Fuel filler pipe and vent pipe
10. Vent hose
11.
Upper fuel filler hose
12. Fuel filler pipe and cup
WBIA0730E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст