Nissan Pathfinder (2010 year). Manual — part 442
HAC-12
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
FUNCTION INFORMATION
Intake door does not change.
Go to Trouble Diagnosis Procedure for Intake Door Motor.
Intake door motor is malfunctioning.
Front blower motor operation is malfunction-
ing.
Go to Trouble Diagnosis Procedure for Front Blower Motor.
Rear blower motor operation is malfunction-
ing.
Go to Trouble Diagnosis Procedure for Rear Blower Motor.
Rear discharge air temperature and/or air
outlet does not change.
Go to Trouble Diagnosis Procedure for Rear Air Control circuit.
Magnet clutch does not engage.
Go to Trouble Diagnosis Procedure for Magnet Clutch.
Insufficient cooling
Go to Trouble Diagnosis Procedure for Insufficient Cooling.
Insufficient heating
Go to Trouble Diagnosis Procedure for Insufficient Heating.
Noise
Go to Trouble Diagnosis Procedure for Noise.
Self-diagnosis cannot be performed.
Go to Trouble Diagnosis Procedure for Self-diagnosis.
Memory function does not operate.
Go to Trouble Diagnosis Procedure for Memory Function.
Symptom
Reference Page
2010 Pathfinder
REFRIGERATION SYSTEM
HAC-13
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
REFRIGERATION SYSTEM
Refrigerant Cycle
INFOID:0000000005476015
REFRIGERANT FLOW
The refrigerant flows in the standard pattern, that is, through the compressor, the condenser with liquid tank,
through the front and rear evaporators, and back to the compressor. The refrigerant evaporation through the
evaporator coils are controlled by front and rear externally equalized expansion valves, located inside the front
and rear evaporator cases.
FREEZE PROTECTION
The compressor cycles on and off to maintain the evaporator temperature within a specified range. When the
evaporator coil temperature falls below a specified point, the intake sensor interrupts the compressor opera-
tion. When the evaporator coil temperature rises above the specification, the intake sensor allows compressor
operation.
Refrigerant System Protection
INFOID:0000000005476016
REFRIGERANT PRESSURE SENSOR
WJIA1342E
2010 Pathfinder
HAC-14
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
REFRIGERATION SYSTEM
The refrigerant system is protected against excessively high- or low-pressures by the refrigerant pressure sen-
sor, located on the condenser. If the system pressure rises above or falls below the specifications, the refriger-
ant pressure sensor detects the pressure inside the refrigerant line and sends a voltage signal to the ECM.
The ECM de-energizes the A/C relay to disengage the magnetic compressor clutch when pressure on the high
pressure side detected by refrigerant pressure sensor is over about 2,746 kPa (28 kg/cm
2
, 398 psi), or below
about 120 kPa (1.22 kg/cm
2
, 17.4 psi).
PRESSURE RELIEF VALVE
The refrigerant system is also protected by a pressure relief valve, located in the rear head of the compressor.
When the pressure of refrigerant in the system increases to an abnormal level [more than 2,990 kPa (30.5 kg/
cm
2
, 433.6 psi)], the release port on the pressure relief valve automatically opens and releases refrigerant into
the atmosphere.
2010 Pathfinder
AUTOMATIC AIR CONDITIONER SYSTEM
HAC-15
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
AUTOMATIC AIR CONDITIONER SYSTEM
Control System Diagram
INFOID:0000000005256906
CONTROL SYSTEM
The control system consists of input sensors, switches, the A/C auto amp. (microcomputer) and outputs.
The relationship of these components is shown in the figure below:
Control System Description
INFOID:0000000005256907
CONTROL OPERATION
AWIIA0223GB
2010 Pathfinder
HAC-16
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
AUTOMATIC AIR CONDITIONER SYSTEM
A/C Auto Amp.
DISPLAY SCREEN
Displays the operational status of the system.
AUTO SWITCH
• Pressing the AUTO switch will illuminate the LED and "Auto" will be visible on the display. The A/C indicator
will illuminate.
• The A/C compressor, intake door, air mix doors, outlet doors and blower speed are automatically controlled
so that the in-vehicle temperature will reach, and be maintained at the set temperature selected by the oper-
ator.
• When pressing AUTO switch, air inlet, air outlet, blower speed, and discharge air temperature are automati-
cally controlled.
• A partial AUTO mode can be achieved by only changing the blower speed or by changing the mode position.
If both the blower speed and the mode positions are changed, the AUTO mode will be cancelled.
TEMPERATURE CONTROL DIAL (DRIVER)
Increases or decreases the set temperature.
TEMPERATURE CONTROL DIAL (PASSENGER)
Increases or decreases the set temperature.
RECIRCULATION (
) SWITCH
• When REC switch is ON, REC switch indicator turns ON, and air inlet is set to REC.
• When REC switch is turned OFF, or when compressor is turned from ON to OFF, REC switch is automati-
cally turned OFF. REC mode can be re-entered by pressing REC switch again.
• REC switch is not operated when DEF switch is turned ON, at the D/F position, or in floor position.
DEFROSTER (
) SWITCH
Positions the air outlet doors to the defrost position. Also positions the intake doors to the outside air position,
and turns A/C compressor ON.
REAR WINDOW DEFOGGER SWITCH
When switch is ON, rear window and door mirrors are defogged.
OFF SWITCH
The A/C compressor and blower are OFF, the intake doors are set to the outside air position, and the air outlet
doors are set to the foot (75% foot and 25% defrost) position.
A/C SWITCH
The compressor is ON or OFF.
(Pressing the A/C switch when the AUTO switch is ON will turn off the A/C switch and compressor.)
MODE SWITCH
Controls the air discharge outlets.
AWIIA0081ZZ
2010 Pathfinder
AUTOMATIC AIR CONDITIONER SYSTEM
HAC-17
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
FRONT BLOWER CONTROL SWITCHES
Manually control the blower speed.
Rear Air Controls
TEMPERATURE CONTROL DIAL (TEMPERATURE AND MODE CONTROL)
The temperature increases or decreases the set temperature. The mode also changes from foot at full hot set-
ting, to foot/vent at mid-range (warm) setting, and then to vent at full cold setting.
REAR BLOWER CONTROL DIAL (FRONT)
When the REAR CTRL switch is in the off (indicator off) the rear air control (front) controls the rear blower
motor speed regardless of the rear air control (rear) blower control dial (rear) position. The rear air control
(front) controls the blower motor speed.
REAR BLOWER CONTROL DIAL (REAR)
When the REAR CTRL switch is on (indicator on) the rear air control (rear) controls the rear blower motor
speed regardless of the rear air control (front) blower control dial (front) position. The rear air control (rear)
controls the blower motor speed.
MAGNET CLUTCH CONTROL
When A/C switch or DEF switch is pressed, A/C auto amp. inputs compressor ON signal to BCM.
BCM sends compressor ON signal to ECM and A/C auto amp., via CAN communication line.
AWIIA0224ZZ
1.
Rear air control (front)
2.
Rear air control (rear)
AWIIA0089GB
2010 Pathfinder
HAC-18
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
AUTOMATIC AIR CONDITIONER SYSTEM
ECM judges whether compressor can be turned ON, based on each sensor status (refrigerant pressure sen-
sor signal, throttle angle sensor, etc.). If it judges compressor can be turned ON, it sends compressor ON sig-
nal to IPDM E/R, via CAN communication line.
Upon receipt of compressor ON signal from ECM, IPDM E/R turns air conditioner relay ON to operate com-
pressor.
Discharge Air Flow (Front)
INFOID:0000000005256908
Mode door position
Air outlet/distribution
Vent
Foot
Defroster
100%
0%
—
60%
40%
—
18%
64%
18%
14%
53%
33%
—
13%
87%
LJIA0172E
2010 Pathfinder
AUTOMATIC AIR CONDITIONER SYSTEM
HAC-19
< FUNCTION DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
Switches And Their Control Function (Front)
INFOID:0000000005256909
WJIA1680E
AWIIA0236GB
2010 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст