Nissan Pathfinder (2010 year). Manual — part 152
KEYFOB ID SET UP WITH CONSULT-III
DLK-115
< COMPONENT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
KEYFOB ID SET UP WITH CONSULT-III
ID Code Entry Procedure
INFOID:0000000005259971
KEYFOB ID SET UP WITH CONSULT-III
NOTE:
•
If a keyfob is lost, the ID code of the lost keyfob must be erased to prevent unauthorized use. A spe-
cific ID code can be erased with CONSULT-III. However, when the ID code of a lost keyfob is not
known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all
remaining and/or new keyfobs must be re-registered.
•
When registering an additional keyfob, the existing ID codes in memory may or may not be erased. If
five ID codes are stored in memory when an additional code is registered, only the oldest code is
erased. If less than five codes are stored in memory when an additional code is registered, the new
ID code is added and no ID codes are erased.
•
Entry of a maximum of five ID codes is allowed. When more than five codes are entered, the oldest ID
code will be erased.
•
Even if the same ID code that is already in memory is input, the same ID code can be entered. The
code is counted as an additional code.
1. Turn ignition switch ON.
2. Select “BCM”.
3. Select “MULTI REMOTE ENT”.
4. Select “WORK SUPPORT”.
5. You can register, erase or confirm a keyfob ID code. To register a new code, select the following option
and follow CONSULT-III instructions:
• “REMO CONT ID REGIST”
Use this mode to register a keyfob ID code.
NOTE:
Register the ID code when keyfob or BCM is replaced, or when additional keyfob is required.
• “REMO CONT ID ERASUR”
Use this mode to erase a keyfob ID code.
• “REMO CONT ID CONFIR”
Use this mode to confirm if a keyfob ID code is registered or not.
2010 Pathfinder
DLK-116
< COMPONENT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
KEYFOB ID SET UP WITHOUT CONSULT-III
KEYFOB ID SET UP WITHOUT CONSULT-III
ID Code Entry Procedure
INFOID:0000000005259972
KEYFOB ID SET UP WITHOUT CONSULT-III
NOTE:
• If a keyfob is lost, the ID code of the lost keyfob must be erased to prevent unauthorized use. A specific ID
code can be erased with CONSULT-III. However, when the ID code of a lost keyfob is not known, all control-
LIIA1670E
2010 Pathfinder
KEYFOB ID SET UP WITHOUT CONSULT-III
DLK-117
< COMPONENT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
ler ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new key-
fobs must be re-registered.
To erase all ID codes in memory, register one ID code (keyfob) five times. After all ID codes are erased, the
ID codes of all remaining and/or new keyfobs must be re-registered.
• When registering an additional keyfob, the existing ID codes in memory may or may not be erased. If five ID
codes are stored in memory, when an additional code is registered, only the oldest code is erased. If less
than five ID codes are stored in memory, when an additional ID code is registered, the new ID code is added
and no ID codes are erased.
• If you need to activate more than two additional new keyfobs, repeat the procedure “Additional ID code
entry” for each new keyfob.
• Entry of maximum five ID codes is allowed. When more than five ID codes are entered, the oldest ID code
will be erased.
• Even if same ID code that is already in the memory is input, the same ID code can be entered. The code is
counted as an additional code.
2010 Pathfinder
DLK-118
< COMPONENT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
HOMELINK UNIVERSAL TRANSCEIVER
HOMELINK UNIVERSAL TRANSCEIVER
Wiring Diagram
INFOID:0000000005259973
AWKWA0054GB
2010 Pathfinder
HOMELINK UNIVERSAL TRANSCEIVER
DLK-119
< COMPONENT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
Description
INFOID:0000000005259974
Homelink universal transceiver can store and transmit a maximum of 3 radio signals.
Allows operation of garage doors, gates, home and office lighting, entry door locks and security system, etc.
Homelink universal transceiver power supply uses vehicle battery, which enables it to maintain every program
in case battery is discharged or removed.
ABKIA1720GB
2010 Pathfinder
DLK-120
< COMPONENT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
HOMELINK UNIVERSAL TRANSCEIVER
Component Function Check
INFOID:0000000005259975
1.
CHECK FUNCTION
Check that system receiver (garage door opener, etc.) operates with original hand-held transmitter.
Is the inspection result normal?
YES
>> GO TO 2
NO
>> Receiver or hand-held transmitter is malfunctioning.
2.
CHECK ILLUMINATION
1. Turn ignition switch “OFF”.
2. Press each of the transmitter buttons and watch for the red light
to illuminate with each button.
Is the inspection result normal?
YES
>> GO TO 3
NO
>> Refer to
DLK-120, "Diagnosis Procedure"
.
3.
CHECK TRANSMITTER
Check transmitter with Tool*.
*:For details, refer to Technical Service Bulletin.
Is the inspection result normal?
YES
>> Receiver or hand-held transmitter malfunction, not vehicle related.
NO
>> Replace auto anti-dazzling inside mirror (homelink universal transceiver).
Diagnosis Procedure
INFOID:0000000005259976
Regarding Wiring Diagram information, refer to
1.
CHECK POWER SUPPLY
1. Disconnect auto anti-dazzling inside mirror (homelink universal transceiver) connector.
2. Check voltage between auto anti-dazzling inside mirror
(homelink universal transceiver) harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 2
PIIA4815E
ALKIA0426ZZ
Auto anti-dazzling inside mirror
(Homelink universal transceiver)
connector
Terminal Condition
Voltage (V)
(Approx.)
R7
10
Ground
Ignition switch position: LOCK
Battery voltage
2010 Pathfinder
HOMELINK UNIVERSAL TRANSCEIVER
DLK-121
< COMPONENT DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
NO
>> Check the following.
• 10A fuse [No. 19 located in the fuse block (J/B)]
• Harness for open or short between fuse and auto anti-dazzling inside mirror (homelink universal
transceiver).
2.
CHECK GROUND CIRCUIT
Check continuity between auto anti-dazzling inside mirror (homelink
universal transceiver) harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 3
NO
>> Repair harness.
3.
CHECK INTERMITTENT INCIDENT
GI-37, "Intermittent Incident"
.
>> Inspection End.
ALKIA1245ZZ
Auto anti-dazzling inside mirror
(Homelink universal transceiver) connector
Terminal
Ground
Continuity
R7
3
Yes
2010 Pathfinder
DLK-122
< ECU DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
BCM (BODY CONTROL MODULE)
ECU DIAGNOSIS
BCM (BODY CONTROL MODULE)
Reference Value
INFOID:0000000005483723
VALUES ON THE DIAGNOSIS TOOL
Monitor Item
Condition
Value/Status
AIR COND SW
A/C switch OFF
OFF
A/C switch ON
ON
AUT LIGHT SYS
Outside of the room is dark
OFF
Outside of the room is bright
ON
AUTO LIGHT SW
Lighting switch OFF
OFF
Lighting switch AUTO
ON
BACK DOOR SW
Back door closed
OFF
Back door opened
ON
CDL LOCK SW
Door lock/unlock switch does not operate
OFF
Press door lock/unlock switch to the LOCK side
ON
CDL UNLOCK SW
Door lock/unlock switch does not operate
OFF
Press door lock/unlock switch to the UNLOCK side
ON
DOOR SW-AS
Front door RH closed
OFF
Front door RH opened
ON
DOOR SW-DR
Front door LH closed
OFF
Front door LH opened
ON
DOOR SW-RL
Rear door LH closed
OFF
Rear door LH opened
ON
DOOR SW-RR
Rear door RH closed
OFF
Rear door RH opened
ON
ENGINE RUN
Engine stopped
OFF
Engine running
ON
FR FOG SW
Front fog lamp switch OFF
OFF
Front fog lamp switch ON
ON
FR WASHER SW
Front washer switch OFF
OFF
Front washer switch ON
ON
FR WIPER LOW
Front wiper switch OFF
OFF
Front wiper switch LO
ON
FR WIPER HI
Front wiper switch OFF
OFF
Front wiper switch HI
ON
FR WIPER INT
Front wiper switch OFF
OFF
Front wiper switch INT
ON
FR WIPER STOP
Any position other than front wiper stop position
OFF
Front wiper stop position
ON
HAZARD SW
When hazard switch is not pressed
OFF
When hazard switch is pressed
ON
LIGHT SW 1ST
Lighting switch OFF
OFF
Lighting switch 1st
ON
2010 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст