Nissan Silvia. Manual — part 63
Forward and Overrun Clutches
COMPONENTS
NMAT0134
SAT454K
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Forward and Overrun Clutches
AT-249
SAT860A
DISASSEMBLY AND ASSEMBLY
NMAT0135
Forward and overrun clutches are serviced essentially the same
way as reverse clutch is serviced. However, note the following
exceptions.
I
Check of forward clutch operation
SAT861A
I
Check of overrun clutch operation
SAT865A
I
Removal of forward clutch drum
Remove forward clutch drum from transmission case by hold-
ing snap ring.
SAT862A
I
Removal of forward clutch and overrun clutch pistons
a)
While holding overrun clutch piston, gradually apply com-
pressed air to oil hole.
SAT863A
b)
Remove overrun clutch from forward clutch.
REPAIR FOR COMPONENT PARTS
Forward and Overrun Clutches (Cont’d)
AT-250
SAT864A
I
Removal and installation of return springs
SAT829A
I
Inspection of forward clutch and overrun clutch return springs
Inspection standard:
Refer to SDS, AT-289.
SAT845A
I
Inspection of forward clutch drive plates
Thickness of drive plate:
Standard
1.52 - 1.67 mm (0.0598 - 0.0657 in)
Wear limit
1.40 mm (0.0551 in)
SAT845A
I
Inspection of overrun clutch drive plates
Thickness of drive plate:
Standard
1.90 - 2.05 mm (0.0748 - 0.0807 in)
Wear limit
1.80 mm (0.0709 in)
SAT866A
I
Installation of forward clutch piston and overrun clutch piston
a)
Install forward clutch piston by turning it slowly and evenly.
I
Apply ATF to inner surface of clutch drum.
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Forward and Overrun Clutches (Cont’d)
AT-251
SAT867A
I
Align notch in forward clutch piston with groove in for-
ward clutch drum.
SAT868A
b)
Install overrun clutch by turning it slowly and evenly.
I
Apply ATF to inner surface of forward clutch piston.
SAT869A
I
Measurement of clearance between retaining plate and snap
ring of overrun clutch
Specified clearance:
Standard
1.0 - 1.4 mm (0.039 - 0.055 in)
Allowable limit
2.0 mm (0.079 in)
Retaining plate:
Refer to SDS, AT-291.
SAT870A
I
Measurement of clearance between retaining plate and snap
ring of forward clutch
Specified clearance:
Standard
0.35 - 0.75 mm (0.0138 - 0.0295 in)
Allowable limit
2.15 mm (0.0846 in)
Retaining plate:
Refer to SDS, AT-291.
REPAIR FOR COMPONENT PARTS
Forward and Overrun Clutches (Cont’d)
AT-252
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст