Nissan Silvia. Manual — part 59
SAT676A
Pilot Filter
NMAT0118S03
I
Check to make sure that filter is not clogged or damaged.
SAT149G
Torque Converter Clutch Solenoid Valve
NMAT0118S04
I
Check that filter is not clogged or damaged.
I
Measure resistance. Refer to “Component Inspection”, AT-120.
Line Pressure Solenoid Valve
NMAT0118S05
I
Check that filter is not clogged or damaged.
I
Measure resistance. Refer to “Component Inspection”, AT-136.
SAT095B
3-Unit Solenoid Assembly (Overrun Clutch Solenoid
Valve and Shift Solenoid Valves A and B)
NMAT0118S06
I
Measure resistance of each solenoid. Refer to “Component
Inspection”, AT-106, AT-111, AT-116.
SAT196B
A/T Fluid Temperature Sensor
I
Measure resistance. Refer to “Component Inspection”, AT-125.
SAT671A
ASSEMBLY
NMAT0119
1.
Install upper and lower bodies.
a.
Place oil circuit of upper body face up. Install steel balls in their
proper positions.
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Control Valve Assembly (Cont’d)
AT-233
SAT681A
b.
Install reamer bolts from bottom of upper body.
SAT682A
c.
Place oil circuit of lower body face up. Install orifice check
spring, orifice check valve and pilot filter.
SAT197B
d.
Install lower separator plate on lower body.
e.
Install and temporarily tighten support plates, A/T fluid tem-
perature sensor and tube brackets.
SAT198B
f.
Temporarily assemble lower and upper bodies, using reamer
bolt as a guide.
I
Be careful not to dislocate or drop steel balls, orifice
check spring, orifice check valve and pilot filter.
REPAIR FOR COMPONENT PARTS
Control Valve Assembly (Cont’d)
AT-234
SAT199BA
g.
Install and temporarily tighten bolts and tube brackets in their
proper locations.
Bolt length and location:
Bolt symbol
a
b
c
d
Bolt length mm (in)
70 (2.76)
50 (1.97)
33 (1.30)
27 (1.06)
SAT200B
2.
Install solenoids.
a.
Attach O-ring and install torque converter clutch solenoid valve
and side plates onto lower body.
SAT150G
b.
Attach O-rings and install 3-unit solenoids assembly onto
upper body.
c.
Attach O-ring and install line pressure solenoid valve onto
upper body.
3.
Tighten all bolts.
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Control Valve Assembly (Cont’d)
AT-235
Control Valve Upper Body
COMPONENTS
NMAT0120
SAT142JA
Apply ATF to all components before their installation.
Numbers preceding valve springs correspond with those shown in SDS on page AT-289.
REPAIR FOR COMPONENT PARTS
Control Valve Upper Body
AT-236
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст