Freightliner FLA/FLB/FLC/FLD/FLL. Manual — part 3
The M1 Maintenance Interval Operations table lists
all maintenance operations that are to be performed
at the M1 maintenance interval. Maintenance opera-
tion numbers are reference numbers used to help
you find detailed instructions in this manual on the
maintenance operations to be performed.
IMPORTANT: After performing all operations listed in
this table, perform all daily, weekly, and monthly
maintenance operations listed in the "Pretrip and
Post-Trip Inspections and Maintenance" chapter of
the vehicle driver’s manual.
M1 Maintenance Interval Operations for Service Schedules I, II, and III
M1 Maintenance Interval Operations for Service Schedules I, II, and III
Maintenance
Operation Number
Operation Description
Check
Lubrication and Fluid Level Check (includes the following)
•
Clutch Release Bearing Lubricating
•
Clutch Release Cross-Shaft Lubricating
•
Clutch Linkage Components Lubricating
•
Shift Control Telescoping Tubes Lubricating and Inspecting, FLA/FLB
•
Shift Control Latch Lubricating and Cylinder Inspecting, FLA/FLB
•
Selection Lever and Pivot Rod Ball Stud Lubricating, FLA/FLB
•
Transmission Oil Level Checking and Breather Checking
•
Fifth Wheel Lubricating
•
Trailer Electrical Connector Lubricating
•
Suspension Lubricating, Front and Rear
•
Knuckle Pin Lubricating
•
Tie-Rod End Inspecting and Lubricating
•
Axle Breather and Lubricant Level Checking
•
Driveline Lubricating
•
Manual/Automatic Slack Adjuster Lubricating and Checking (All Models)
•
Steering Driveline Lubricating
•
Ross Manual Steering Gear Lubricant Checking, Model 503
•
Drag Link and Power Steering Cylinder Lubricating
•
Power Steering Reservoir Fluid Level Checking
•
Ross Power Steering Gear Lubricating, TAS Series
•
Sheppard Power Steering Gear Bearing Cap Lubricating
•
Cab-Tilt System Checking, FLA/FLB
•
Door Seal, Door Latch, and Door Hinge Lubricating
Bendix Air Compressor Inspecting
Fifth Wheel Inspecting
Suspension Inspecting
Driveline Inspecting
Brake Adjusting—Cam Brakes With Manual Slack Adjusters
General Information
00
M1 Maintenance Interval Operations Table: 00-07
00/13
M1 Maintenance Interval Operations for Service Schedules I, II, and III
Maintenance
Operation Number
Operation Description
Check
Wedge Brake Checking
Bendix Air Dryer or Anchorlok Aftercooler Inspecting (Bendix AD–2, AD–4, AD–9, or
Anchorlok)
CR Brakemaster Air Dryer Cleaning (Model 62 or 68)
Midland Quick Release and Flipper Valve Checking
Brake Inspection
Fuel Tank Band Nut Tightening, FLA, FLB, and FLD
Cab Latch Checking, FLA/FLB
Exhaust System Inspecting
General Information
00
M1 Maintenance Interval Operations Table: 00-07
00/14
The M2 Maintenance Interval Operations table lists
all maintenance operations that are to be performed
at the M2 maintenance interval. Maintenance opera-
tion numbers are reference numbers used to help
you find detailed instructions in this manual on the
maintenance operations to be performed. Perform all
M1 maintenance interval operations at the M2 main-
tenance interval.
NOTE: Maintenance operations appearing in italics in
this table are for noise emission control components.
Numbers in this table are reference numbers match-
ing those in the text of this manual.
M2 Maintenance Interval Operations for Service Schedules I, II, and III
M2 Maintenance Interval Operations for Service Schedules I, II, and III
Maintenance
Operation Number
Operation Description
Check
Perform all M1 Operations
Jacobs Engine Brake Wiring Inspecting
Radiator Cap Checking
Fan Drive and Clutch Checking
Manual Transmission Magnetic Plug Cleaning, Oil Changing, and Oil Filter Element
Changing
Transmission Air Filter/Regulator Checking, and Cleaning or Replacing
Holland Fifth Wheel Sliding Mechanism Inspecting
Wheel Nut and Rim Nut Checking
Camshaft Bracket Bushing Lubricating
Meritor Automatic Slack Adjuster Inspecting
Alcohol Evaporator Checking
Bendix Alcohol Evaporator Cleaning
Anchorlok Aftercooler Automatic Ejector Valve Clearing
Bendix Air Brake Valve Disassembly, Cleaning, Inspecting, and Lubricating (DV–2,
PP–3, and Single Check Valve)
Sealco Moisture Ejection Valve Operation- and Leak-Testing (Model 6300)
Power Steering Reservoir Fluid and Filter Changing
Steering Driveline Deck Bearing Lubricating, FLA/FLB
Fuel Tank Vent Checking
Fuel Separator Sight Bowl Cleaning and Element Replacing
Cab-Suspension Spring Center-Bolt Torque Checking, FLC
Air Conditioner Inspecting
General Information
00
M2 Maintenance Interval Operations Table: 00-08
00/15
The M3 Maintenance Interval Operations table lists
all maintenance operations that are to be performed
at the M3 maintenance interval. Maintenance opera-
tion numbers are reference numbers used to help
you find detailed instructions in this manual on the
maintenance operations to be performed. Perform all
maintenance interval operations in M1 and M2 when
performing M3 maintenance interval operations.
NOTE: Maintenance operations appearing in italics in
this table are for noise emission control components.
Numbers in this table are reference numbers match-
ing those in the text of this manual.
M3 Maintenance Interval Operations for Service Schedules I, II, and III
M3 Maintenance Interval Operations for Service Schedules I, II, and III
Maintenance
Operation Number
Operation Description
Check
Perform all MI Operations
Perform all M2 Operations
Engine Rear-Support Assembly Checking
Engine Noise Panel Inspecting
Engine Drive Belt Inspecting
Air Cleaner Element Inspecting and Replacing
Alternator, Battery, and Starter Checking
Shift Lever Pivot Yokes Inspecting, FLA/FLB
Suspension U-Bolt Torque Checking
Axle Lubricant Changing, Oil Filter Replacing, and Magnetic Strainer Cleaning
Wedge Brake Inspecting and Lubricating
Bendix Alcohol Evaporator Gasket Replacing
Bendix Air Dryer Checking (AD–2, AD–4, or AD–9)
Bendix Air Brake Valve Operation Checking (BP–R1 and E–12)
Bendix Air Brake Valve Disassembly, Cleaning, and Inspecting (BP–1, Double Check
Valve, E–6, PP–7, QR–1, R–6, R–14, SR–1, ST–3, TC–7, TP–5, and TR–3)
Bendix Air Brake Valve Inspecting and Testing (BP–1, BP–R1, LQ–5, PP–7, R–14
and TC–7)
Bendix Foot Brake Valve Actuator Lubricating (E–6 or E–12) and Leak-Testing (E–
12)
Ross Manual Steering Gear Lubricant Changing, Model 503
Electrical System Checking
Speedometer/Tachometer Cable Lubricating
General Information
00
M3 Maintenance Interval Operations Table: 00–09
00/16
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст