Freightliner Coronado 132 / 122SD. Manual — part 3
Maintenance for Service Schedules III and IV
Maint. No.
Maintenance Interval
Service
Date
Service Schedules III and IV
Miles
km
36
M1, M2, and M3
900,000
1 448 000
37
M1
925,000
1 490 000
38
M1
950,000
1 529 000
39
M1
975,000
1 569 000
40
M1 and M2
1,000,000
1 609 000
Table 4, Maintenance for Service Schedules III and IV
General Information
00
Vehicle Maintenance Schedule Tables: 00–02
00/7
The Initial Maintenance table lists all maintenance
operations that are to be performed at the initial
maintenance (IM) interval. Maintenance operation
numbers are reference numbers used to help you
find detailed instructions in this manual on the main-
tenance operations to be performed. All operations
listed in the table, along with the operations listed in
the applicable M1 maintenance interval table, must
be performed to complete the initial maintenance
(IM).
Maintenance
Operation Number
Initial Maintenance (IM) Operations for Service Schedules I, II, III, and IV
• Schedule I: at 1000 miles (1600 km) or 50 hours
• Schedule II: at 10,000 miles (16 000 km)
• Schedule III: at 25,000 miles (40 000 km)
Check
Perform all M1 Operations
Frame Fastener Torque Check
Premier 690 Coupling Inspection
Suspension U-Bolt Torque Check
All-Axle Alignment Check
Wheel Nut Check
Fuel Tank Band-Nut Tightening
Table 5, Initial Maintenance (IM) Operations for Service Schedules I, II, III, and IV
General Information
00
Initial Maintenance (IM) Operations: 00–03
00/8
The M1 Maintenance Interval Operations tables list
all maintenance operations that are to be performed
at the M1 maintenance interval. Maintenance opera-
tion numbers are reference numbers used to help
you find detailed instructions in this manual on the
maintenance operations to be performed.
IMPORTANT: After performing all operations listed in
this table, perform all daily, weekly, and monthly
maintenance operations listed in the "Pretrip and
Post-Trip Inspections and Maintenance" chapter of
the 122SD and Coronado 132 Driver’s Manual.
Maintenance
Operation Number
M1 Maintenance Interval Operations for Service Schedules I, II, and III
• Schedule I: every 1000 miles (1600 km) or 50 hours
• Schedule II: every 10,000 miles (16 000 km)
• Schedule III: every 25,000 miles (40 000 km)
Check
Air Compressor Inspection
Eaton Fuller Heavy-Duty Clutch Release Bearing Lubrication
Allison Transmission Fluid and Filter Change (TES 389 or Dexron-VI)
Fifth Wheel Inspection
Fifth Wheel Lubrication
Trailer Electrical Connector Lubrication
Premier 690 Coupling Inspection
Suspension Lubrication
Knuckle Pin Lubrication, Detroit
™
and Dana Spicer Axles
*
Tie Rod Lubrication, Detroit and Dana Spicer Axles
*
Tire Check
Driveline Inspection
Driveline Lubrication
Bendix Air Dryer Desiccant Replacement (with an oil-coalescing desiccant cartridge)
†
Brake Inspection
Meritor Camshaft Bracket Lubrication
Dana Spicer Camshaft Bracket Lubrication
Dana Spicer, Haldex, and Gunite Slack Adjuster Lubrication
WABCO System Saver Air Dryer Desiccant Cartridge Replacement
†
Versajust Slack Adjuster Inspection and Lubrication
‡
Exhaust System Inspection (noise emission control)
Aerodynamic Component Inspection
Door Seal and Door Latch Lubrication
Hood Rear Support Lubrication
*
For Detroit axles, complete this procedure once a year or at the following applicable interval, whichever comes first: every 5000 miles (8000 km) for Schedule
I vehicles; every 25,000 miles (40 000 km) for Schedule II vehicles; or every 100,000 miles (161 000 km) for Schedule III vehicles.
†
If equipped with an oil-coalescing desiccant cartridge, replace the cartridge once a year, regardless of mileage. Otherwise use the M3 maintenance interval.
‡
Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
Table 6, M1 Maintenance Interval Operations for Service Schedules I, II, and III
General Information
00
M1 Maintenance Interval Operations: 00–04
00/9
Maintenance
Operation Number
M1 Maintenance Interval Operations for Service Schedule IV
• Schedule IV: every 25,000 miles (40 000 km)
Check
Air Compressor Inspection
Fifth Wheel Inspection
Fifth Wheel Lubrication
Trailer Electrical Connector Lubrication
Premier 690 Coupling Inspection
Tire Check
Bendix Air Dryer Desiccant Replacement (with an oil-coalescing desiccant cartridge)
*
Brake Inspection
Meritor Camshaft Bracket Lubrication
WABCO System Saver Air Dryer Desiccant Cartridge Replacement
*
Versajust Slack Adjuster Inspection and Lubrication
†
Exhaust System Inspection (noise emission control)
Aerodynamic Component Inspection
Door Seal and Door Latch Lubrication
Hood Rear Support Lubrication
*
If equipped with an oil-coalescing desiccant cartridge, replace the cartridge once a year, regardless of mileage. Otherwise use the M3 maintenance interval.
†
Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
Table 7, M1 Maintenance Interval Operations for Service Schedule IV
General Information
00
M1 Maintenance Interval Operations: 00–04
00/10
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст