Freightliner Century Class. Manual — part 3
Maintenance Operation 00–04
Lubrication and Fluid Level Check for Service Schedules I, II, III, and IV
Maint.
Operation
Number
Operation Description
Service
Schedules I, II,
and III (at M1)
Service
Schedule IV
(at M2)
Check
Hood Rear Support Lubrication
•
*
For Schedule II vehicles with Detroit axles, complete this procedure once a year or every 25,000 miles (40 000 km), whichever comes first.
†
Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
General Information
00
Lubrication and Fluid Level Check: 00–04
00/9
tenance operations to be performed. All operations
listed in the table, along with the operations listed in
the applicable M1 maintenance interval table, must
be performed to complete the initial maintenance
(IM).
Maintenance
Operation Number
Check
Perform all M1 Operations
Frame Fastener Torque Check
Premier 690 Coupling Inspection
Suspension U-Bolt Torque Check
All-Axle Alignment Check
Wheel Nut and Rim Nut Check
Fuel Tank Band-Nut Tightening
General Information
00
00/10
Maintenance
Operation Number
Check
Lubrication and Fluid Level Check (includes the following):
• Eaton Fuller Clutch Release Bearing Lubrication
• Fifth Wheel Lubrication
• Trailer Electrical Connector Lubrication
• Suspension Lubrication
• Knuckle Pin Lubrication, Dana Spicer Axles
• Tie Rod Lubrication, Dana Spicer Axles
• Driveline Lubrication
• Dana Spicer Camshaft Bracket Lubrication
• Dana Spicer, Haldex, and Gunite Slack Adjuster Lubrication
• Cab Tilt Pump Reservoir Fluid Level and System Check
• Door Seal, Door Latch, and Door Hinge Lubrication
• Hood Rear Support Lubrication
Air Compressor Inspection
Fan Clutch Check (noise emission control)
Fifth Wheel Inspection
Premier 690 Coupling Inspection
Tire Check
Driveline Inspection
Meritor Camshaft Bracket Lubrication
Brake Inspection
Versajust Slack Adjuster Inspection and Lubrication
*
Exhaust System Inspection (noise emission control)
*
Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
Maintenance
Operation Number
Check
Air Compressor Inspection
Fan Clutch Check (noise emission control)
Fifth Wheel Inspection
Fifth Wheel Lubrication
General Information
00
00/11
Maintenance
Operation Number
Check
Trailer Electrical Connector Lubrication
Tire Check
Meritor Camshaft Bracket Lubrication
Brake Inspection
Versajust Slack Adjuster Inspection and Lubrication
*
Exhaust System Inspection (noise emission control)
Cab Tilt Pump Reservoir Fluid Level and System Check
Door Seal, Door Latch, and Door Hinge Lubrication
Hood Rear Support Lubrication
*
Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
General Information
00
00/12
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст