Kia Carnival (2007 year). Manual — part 383

2007 > 2.7L V6 GASOLINE >

ADUSTMENT

CORRECTION MODE

1. The correction process is necessary for displaying correct direction of by removing the effect of magnetized car

body components.

2. Push Mode button for 2 sec - 4.5 sec. And then "turn" is displayed and "DIR" is blinking with 0.5 sec intervals.

3. Automatic correction is done when the vehicle turns 720° in normal driving condition (the correction is invisible to

the driver).

a. The correction data is updated if the automatic correction data is better than the present correction data.

b. Turning direction is not important.

c. If the correction process is not finished after the vehicle turns 720°, turn the vehicle some more degree.

4. After finishing the correction process, the compass displays the present direction.

5. If the correction process is not finished until 5 minutes this mode is cancelled and the compass returns to normal

mode with restoring the previous correction data.

DECLINATION CORRECTION (VARIANT REGION CHANGE MODE)

1. Change the "Declination Setting Value" according to the regional declination to synchronize the true north and

vehicle's north.

2. Push the mode button longer than 4.5 Sec to enter the declination correction mode. ('DIR' is on)

3. Screen after 4.5 sec.

4. Push the reset button longer than 0.1 Sec to change the declination setting Value (Steps by 5° to East. After East

30, wraps to West 30)

5. Push the mode button more than 1sec, new data is stored on EEPROM and VFD displays normal direction.

6. Without any effective input for 30 seconds, the trip computer displays the previous declination angle with blinking

for 2 sec and displays normal direction.

a. Do not install a ski rack, antenna, etc. that are attached to the vehicle using a magnet as anything attached

to the roof of the vehicle with a magnet will effect compass operation.

b. If the compass deviates from the correct indication soon after repeated adjustment, have the compass

checked at an authorized dealer.

c. The compass may not indicate the correct compass point in tunnels or while driving up or down a steep

hill. (The compass returns to the correct compass point when the vehicle moves to an area where the
geomagnetism is stabilized.)

a. Declination correction and correction setting value is not deleted during the B(+) OFF.

DISPLACEMENT

1. Disconnect the negative (-) battery terminal.

2. Remove the lens and open the sunglass case cover from the overhead console then remove the 2 screws holding

the overhead console. And disconnect the connector then remove the overhead console lamp assembly from the
headliner.

3. Remove the trip computer(A) mounting screws (3EA), and then disconnect from the overhead console.

4. Installation is the reverse of removal.

Rear Parking Assist System

Rear Parking Assist System

Control Unit