Kia Carnival (2007 year). Manual — part 28

29.4 ~ 41.2Nm(3.0 ~ 4.2kgf.m, 21.7 ~ 30.4lb-ft

Use new O-rings and wet them with water or coolant when reassembling.

3. Install the wiring protector.

4. Connect the heater hose and ECT hose.

5. Connect the ECT sensor connector.

6. Connect the radiator upper and the lower hose(A).

7. Install the air cleaner assembly.

8. Fill with engine coolant.

9. Start engine and check for leaks.

10. Recheck engine coolant level.

THERMOSTAT

1. Place thermostat(B) in coolant inlet pitting(A).

Install the thermostat with the jiggle valve upward.

2. Install the coolant inlet pitting(A).

Tightening torque
16.66 ~ 19.60Nm (1.7 ~ 2.0kgf.m, 12.30 ~ 14.47lb-ft)

3. Fill with engine coolant.

4. Start engine and check for leaks.

RADIATOR

1. Install the radiator fan(A) to the radiator.

Tightening torque
4.9 ~ 7.8Nm (0.5 ~ 0.8kgf.m, 3.6 ~ 5.8lb-ft)

2. Install the radiator assembly to the vehicle.

3. Fix the condenser with the radiator assembly.

Tightening torque
4.9 ~ 7.8Nm (0.5 ~ 0.8kgf.m, 3.6 ~ 5.8lb-ft) - D
6.9 ~ 9.8Nm (0.7 ~ 1.0kgf.m, 5.1 ~ 7.2lb-ft) - C

4. Install the radiator bracket(A, B) and the bleeder hose(C).

LH

RH

5. Connect the radiator fan connectors(A,B)

LH

RH

6. Install the transaxle oil cooler hoses(A).(Refer to TR group)

7. Install the radiator upper(A) and lower hoses(B).

8. Install the radiator support upper member assembly(A).

9. Install the radiator grille upper cover(A).

10. Fill with engine coolant.

11. Start engine and check for leaks.

12. Recheck engine coolant level.

INSPECTION

WATER PUMP

1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.

2. Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if

necessary.

3. Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly.

A small amount of "weeping" from the bleed hole is normal.