Kia Carnival (2007 year). Manual — part 537

12. Install the RH timing chain guide (A).

Tightening torque :
19.60 ~ 24.50N.m(2.0 ~ 2.5kgf.m, 14.17 ~ 18.08lb-ft)

13. Install the RH timing chain.

To install the timing chain with no slack between each shaft (cam, crank), follow the procedure below.
Crankshaft sprocket (A) → Intake camshaft sprocket (B) → Exhaust camshaft sprocket (C).
The timing mark of each sprocket should be matched with timing mark (color link) of timing chain at installing
timing chain.

14. Install the RH timing chain tensioner arm (B).

Tightening torque :
18.62 ~ 21.56N.m(1.9 ~ 2.2kgf.m, 13.74 ~ 15.91lb-ft)

15. Install the RH timing chain auto tensioner (A).

Tightening torque :
9.80 ~ 11.76N.m(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)

16. Install the RH cam-to-cam guide (A).

Tightening torque :
9.80 ~ 11.76N.m(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)

17. Install the oil pump chain guide (A).

Tightening torque :
9.80 ~ 11.76N.m(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)

18. Install the oil pump chain tensioner assembly (A).

Tightening torque :
9.80 ~ 11.76N.m(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)

19. Pull out the pins of hydraulic tensioners (LH & RH).

20. Install the oil pump chain cover (A).

Tightening torque :
9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)

21. After rotating crankshaft 2 revolutions in regular direction (clockwise viewed from front), confirm the timing mark.

Always turn the crankshaft clockwise.

22. Install the timing chain cover.

(1) The sealant locations on chain cover and on counter parts (cylinder head, cylinder block, and lower oil pan)

must be free of engine oil and ETC.

(2) Before assembling the timing chain cover, the liquid sealant TB1217H should be applied on the gap between

cylinder head and cylinder block.
The part must be assembled within 5 minutes after sealant was applied.

Bead width : 2.5mm(0.1in.)

(3) After applying liquid sealant TB1217H on the timing chain cover.

The part must be assembled within 5 minutes after sealant was applied.
Sealant should be applied without discontinuity.

Bead width : 2.5mm(0.1in.)