Kia Carnival (2007 year). Manual — part 336
6. Pull the rear cable (A) and draw the cable clip (B) to bottom of roller hinge post and then remove the rear cable
(A).
7. Remove the roller hinge bracket assembly (A) as below.
8. Remove the front cable (A) from center roller hinge (B).
9. Loosen the bolts (2EA) and remove the rear pulley bracket (A). And then remove the front pulley bracket (B) after
loosening the mounting bolts (2EA) and nut (1EA).
TORQUE : 7 - 11 N.m (0.7 - 1.1 Kg.m)
10. Loosen the mounting bolt (1EA) and nuts (2EA). And then remove the power sliding door drive unit assembly after
removing the front cable.
TORQUE : 7 - 11 N.m (0.7 - 1.1 Kg.m)
11. Installation is the reverse of removal.
12. When installation, check the grease on the center roller hinge barrel and club contact part (A).
a. A learn cycle must be performed whenever the power is removed.
b. Check the normal operation whenever a power sliding door component is removed or replaced. If the
chime sound is heard, check the DTC, wiring harness and cable connections.
Power Sliding Door Control
Module
2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1. Disconnect the negative (-) battery terminal..
2. Remove the rear trim panel (Refer to the Body group - interior trim)
3. Remove the connectors and mounting bolts (2EA) from the power sliding door unit(A). And then remove the power
sliding door control module (B).
TORQUE 0.25-0.35N.m(0.025-0.035Kg.m)
4. Installation is the reverse of removal.
a. A learn cycle must be performed whenever the power is removed.
b. Check the normal operation whenever a power sliding door component is removed or replaced. If the
chime sound is heard, check the DTC, wiring harness and cable connections.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст