Kia Carens. Manual — part 128
Bearing
1. Inspect for wear and rough rotation. If bearing is removed then replace it and bearing race together, and
adjust bearing preload.
Assembly note
Bearing (ring gear side)
1. Install new bearing by using SST(0K011 270 A02).
Bearing (ring gear opposite side)
1. Install speedometer drive gear.
2. Install new bearing by using SST(0K011 270 A02).
Roll pin
1. Install new roll pin as shown in figure to hold pinion shaft.
Backlash of side gear and pinion gear
Measure backlash by following procedure :
1. Install left driveshaft and right joint shaft in differntial assembly.
2. Support shafts on V-blocks as shonw in figure.
3. Measure backlash of both pinion gears.
Backlash : 0.002 ~ 0.006 in (0.05~0.15 mm)
4. If not as specified, replace worn and damaged parts.
Manual Transaxle System
Manual Transaxle Shift Control
Manual Transaxle System
2001 > 1.8L DOHC >
Component
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст