Kia Carens. Manual — part 199
2. If readings do not meet specifications, lift front of vehicle until front wheels clear floor, and supprot with
safety stands.
3. Remove four mounting block nuts.
4. Push mounting block downward to disengage studs, and turn it to position that corresponds to the difference
between the initial reading and the specification.
Alternate positions
Change from starting position
Camber angle
Caster angle
A
0°
32'24"
B
11'35"
32'24"
C
11'35"
0°
5. Install and tighten mounting nuts to specified torque.
Tightening torque : 27~38 lb-ft(37~52 N·m, 3.8~5.3 kg-m)
6. Lower vehicle and recheck caster, camber.
Readjust if necessary.
Toe(total)
1. Measure toe angle with a toe angle gauge, per manufacturer instructions.
2. If measurement does not meet specification, loosen left and right tie rod jam nuts, then turn each tie rod as
needed to achieve proper toe angle.
1) Left and right tie-rods are right hand threaded. To decrease toe angle thread right and left side
tie-rods into tie-rod ends. To increase toe-in, unthread toe-rods.
2) One full turn of both tie rods changes toe-in by about 24 in(6mm).
3) If may be necessary to rotate one tie rod more than the other in order to achieve the proper toe
angle and still retain a straight steering wheel.
3. Tighten tie rod jam nuts.
Tightening torque : 41~55 lb-ft (55~75 N·m, 5.6~7.6kg-m)
Rear wheel alignment
Rear camber is not adjustable.
Adjustment
Toe(total)
1. Check that fuel tank is full ; radiator coolant and engine oil are at specified levels ; and spare tire, jack, and
toolsare in their designated positions. vehicle must be on a level surface.
2. Measure rear toe angle with a toe angle gauge.
3. If specification is not met, loosen rear lateral link jam nuts.
4. Turn lateral link adjuster to adjust left or right tear wheel as needed.
One turn of link changes toe approximately 0.12 in (3 mm)
5. Repeat for other side if necessary.
6. Tighten lateral link jam nuts to specified torque.
Tightening torque : 85~115 lb-ft(116~157 N·m, 11.8~16kg-m)
2001 > 1.8L DOHC >
Specifications
Item
Specifications
Steering angle
maximum
Inner
39°30'
Outer
32°30'
Toe in(mm)
Single wheel (Degree)
-2'52"±10'
Total
185/65R14
-0.039±0.12 in (-1±3 mm)
Camber angle
Degree
0°±30'
Caster angle
Degree
2°27'±45'
Kingpin angle
Degree
12°35'
Rear wheel alignment (No passenger load)
Item
Specifications
Toe-In in(mm)
Single wheel (Degree)
9'16"±10'
Total
185/65R14
0.126±0.12 in (3.2±3 mm)
Camber angle
-1°30'±30'
Wheel and tire
Item
Type
Standard
Wheels
Size
14×5 1/2JJ
Offset in(mm)
1.77
Pitch circle diameter in(mm)
4.5(114.3)
Material
Steel or aluminum
Tire
Size
185/65R14/86H
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст