Kia Carens. Manual — part 98

2001 > 1.8L DOHC >

COMPONENT

2001 > 1.8L DOHC >

REMOVAL

1. Raise vehicle and support it with safety stand.

2. Loosen and remove four wheel nuts.

3. Remove wheel and tire.

4. Remove a dust cap, hub locknut and two brake drum screws.

5. Remove brake drum (or disk) from rear brake assembly.

6. Remove hub with bearing assembly.

After disconnecting brake line, plug it to prevent fluid leakage.

7. Disconnect brake line with SST(OK130 430 019).

8. Remove two bolts and remove rear brake assembly (drum or disc).

9. Disconnect two lateral links and trailing link from spindle.

10. Loosen and remove two struct bolts and nuts.

11. Remove spindle from strut assembly.

12. Check all parts, and repair or replace if necessary.

INSTALLATION

1. Install spindle to strut assembly and tighten two bolts and nuts.

Tightening torque : 69~86lb-ft (93~116N·m, 9.5~11.9kg-m)

2. Install two lateral links to spindle with bolt and then tighten nut.

Tightening torque : 69~86lb-ft (93~116N·m, 9.5~11.9kg-m)

3. Install trailing link to spindle and tighten trailing link bolt.

Tightening torque : 32~45lb-ft (43~61N·m, 4.4~6.2kg-m)

4. Tighten four rear brake assembly (drum or disc) bolts.

Tightening torque : 33~49lb-ft (45~67N·m, 4.6~6.8kg-m)

5. Tighten brake line with SST (OK130 430 019).

Tightening torque : 9~13lb-ft (13~18N·m., 1.3~1.8kg-m)

6. Install hub and bearing assembly.

7. Put brake drum (or disc) into rear brake assembly and tighten two screws.

Tightening torque : 7~11lb-ft (9.8~15N·m, 1.0~1.5kg-m)

8. Install a new hub locknut and stake it, as shown.

Tightening torque : 154~205lb-ft (210~279N·m, 21.4~28.5kg-m)

9. Install hubcap, wheel and tire.

10. Install and tighten four wheel nuts.

11. Bleed brake system.

Tightening torque : 65~87lb-ft (88~118N·m, 9.0~12.0kg-m)

12. Lower vehicle.

13. After assembly, check rear wheel alignment.

Clutch System

General Information

Clutch System